Lascar EL-WiFi-Alert Quick Start Manual

Alert Placement
The Alert device has a built-in WiFi signal
strength indicator. Press the button three
times to locate the range of the router through
the use of visual LED indicators and audible
sound. All LEDs and a fast beep indicate a
strong signal. Limited LEDs and slow beep
indicate a weak signal.
When placing your Alert device consider radio
obstructions. For optimum WiFi performance
you may need to try positioning the unit in
various different locations/positions.
physical obstructions between a router/access
point and an Alert will affect the signal range.
WiFi extenders can also be used to gain
improvements. These can be purchased from
our online store www.TIPTEMP.com.
To optimize the performance
EL-WiFi-Alert make sure you have the most
up-to-date Firmware installed.

Important Safety Information

WARNING: Failure to follow these safety instructions could result
in fire, electrical shock, other injury or damage.
Battery Replacement
The rechargeable battery in the
authorized supplier.
Repairing or Modifying
Never attempt to repair or modify products. Dismantling products, including
the removal of external screws, may cause damage that is not covered under
the warranty. Servicing should only be provided by an authorized supplier. If
the product has been submerged in water, punctured, or seriously damaged
do not use it before returning it to an authorized supplier.
Charging
Only use a USB Power Adaptor or a USB port on another device to charge
Any
products. Read all safety instructions for any third party products and
accessories before use with this product. TIPTEMP is not responsible for the
operation of any third party accessories or their compliance with safety and
regulatory standards. We do not recommend charging the battery when
the unit is at 40˚C (104˚F) or above. Some of our products employ safety
features to prevent this.
Using Connectors and Ports
Never force a connector into a port; check for obstruction in the port, make
sure that the connector matches the port and that you have positioned the
connector correctly in relation to the port. If the connector and port do not
join with reasonable ease they probably do not match and should not be
used.
Disposal and Recycling Information
You must dispose of products according to relevant laws and regulations.
Products contain electronic components and
therefore they must be disposed of separately from household waste.
Subject to change without prior warning
of your
product should only be replaced by an
lithium polymer batteries and
EL-WiFi-Alert
Quick Start Guide