CORONA R8DM Instruction Manual

R8DM /R6DM /R4DM Instruction manual
Thank you for purchasing CORONA's DMSS compatible receiver. This production can supply
enhancement smooth flight with JR DMSS link.
Compatibility:
CORONA 2.4GHz DMSS Compatible Receiver is designed to use with JR DMSS 2.4GHz
transmitters, such as XG6,XG7,XG8 ,XG11 and XG14 under DMSS protocol mode.
Feature:
 8ch,6ch and 4ch servo channels in R8DM,R6DM and R4DM under normal status.
 S.BUS output support expanding servo channels on the 8
th
R6DM and the 4 channel of R4DM under special status.
 13mS latency under linked with XG7,and 14mS latency under linked with other transmitters.

Specifications:

 Voltage Range :3.6~8.5V
 Operating Current: 60mA max and 35mA under linked
 Operation temperature: -10~70 degC
 Latency: 13mS or 14mS
 Sensitivity: about -100dBm for R8DM , -98dBm for R6DM and -96dBm for R4DM
 Weight: 11g for R8DM , 8g for R6DM and 7g for R4DM
Bind procedure:

Turn on the DMSS transmitter, leave it 0.5M~1M away the receiver.

Connect a shorter on CH6 of R8DM , CH4 of R6DM and CH2 of R4DM(signal and
GND) when bind with XG7; and connect a shorter on CH7 of R8DM, CH5 of R6DM
and CH3 of R4DM when bind with other transmitters.

Connect the battery to the receiver(CH1~CH5 or CH8 of R8DM , CH1~ CH3 or CH6
for R6DM, CH1 or CH4 of R4DM) while pressing down receiver's button.

Red LED light on and Green LED off when searching signals, and turn to Green LED
light on and Red LED off indicate bind is succeeded.
Fail-safe setting:
R8DM, R6DM or R4DM set failsafe on the DMSS transmitter just like the operation of the JR's
DMSS receivers. We highly recommend you set failsafe feature while flying your models. An
example of a useful Failsafe setting would be to shut down the model's throttle, so that it does not
fly or drive away uncontrolled.
Special/Normal mode switch guide:
If your receiver has been linked with your transmitter, please power off your transmitter. When
th
channel of R8DM, the 6
th
channel of