Table of Contents
Advertisement
BN68-448D-03Eng-final
Switching On and Off
The mains lead is attached to the rear of your set.
If you have purchased this set in the United Kingdom,
refer to page 57 for further instructions on plug wiring.
1
Plug the mains lead into an appropriate socket.
Result:
The main voltage is indicated on the rear of your set and
the frequency is 50 or 60Hz.
2
Press the POWER (
Result:
The standby indicator lights up on the front panel.
3
Press the POWER ( ), numeric button (0~9) or channel
up/down(
/
C/P.
Result:
The programme that you were watching last is reselected
automatically.
When you switch the set on for the very first time, you will be
asked to choose language in which the menus are to be
displayed (see page 15).
4
To switch your set off, press the POWER (
Placing Your Television in Standby Mode
Your set can be placed in Standby mode, in order to reduce the power
consumption. The Standby mode can be useful when you wish to
interrupt viewing temporarily (during a meal, for example).
1
Press the POWER ( ) button on the remote control.
Result:
The screen is turned off and a orange standby indicator
appears on the front of your set.
2
To switch your set back on, simply press the POWER ( ), numeric
buttons (0~9) or channel up/down (
Do not leave your set in Standby mode for long periods of time
(when you are away on holiday, for example).
Turn your set off by pressing the POWER (
of the set.
It is best to unplug the set from the mains and aerial.
1. Use of the 'Power' button on the remote is possible only when the
TV is in 'Power Saving' (standby) mode. If the TV is powered off,
the remote cannot be used to turn the TV on.
2. To retain the time and or automatic alarm settings, always put the
TV in stand-by mode with the remote control.
Use of the the power switch on the TV will clear all time related
settings.
[Benefit] This full 'power off' function is as effective as unplugging
the power cable.
TV switches to standby mode when powered off by the remote
control. To return power (
control 'ON' or channel button( ). Pressing the power button on
the TV does not return power to the screen because in this case,
the TV restores the last mode, which was 'Power Saving'.
12/20/03 4:32 AM
Page 13
) button on the front of your set.
) button on the remote control or power or
button on the front of your set.
) again.
/
) button again.
) to the screen, press the remote
) button on the front
TV
P.MODE
SELECT
1
2
3
4
5
6
7
8
9
-/--
PRE-CH
0
P
VIDEO
MUTE
POWER
TV
P.MODE
SELECT
TV
P.MODE
SELECT
1
2
3
4
5
6
7
8
9
-/--
PRE-CH
0
P
VIDEO
MUTE
English-13
Advertisement
Table of Contents
