Sotera KITS05WMA Installation Instructions

KITS05WMA 1/2" Air Operated Diaphragm Pump

Wall Mount Bracket Installation Instructions

Figure 1
Figure 2
NOTE: Bracket dimensional drawings on back.
WARNING! Use cau on when installing the bracket,
pump, and associated parts. Use required safety
equipment (goggles, gloves, etc.). Be certain the
bracket and pump are securely installed prior to
opera on.
Step 1: Remove the 3/8" nuts on
the back of the pump body one
at a time (Figure 1). This is best
accomplished by loosening the
bolts on the front one at a time
(Figure 2); once each bolt is
loose, press it back into the hole
to push the nut out of the pump
body. Repeat for each nut.

Step 2: Press the coupler nuts

one at a time into the pump
body and tighten the 3/8" bolts
to secure them into place
(Figure 3). Torque them to 25
inch pounds.
NOTE! Install exhaust
components (muffler, etc.)
PRIOR to installing the bracket
on the pump.
Step 3: Attach the bracket to
the to the back of the pump
(Figure 4) using the four 3/8"
bolts provided with the kit. The
bolts thread into the coupler
nuts; insert the 1/4" split
washers as indicated between
the bolt and the bracket.
Tighten the 3/8" bolts to 25 inch
lbs.
Required tools:
3/8" socket or nut driver
7/16" socket or nut driver
Figure 3
Figure 4