GE Profile PEB9159SJSS Dimensions And Installation Information

PEB9159SJSS
GE Profile Series 1.5 Cu. Ft. Countertop Convection/Microwave Oven
™
DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)
EXTERIOR DIMENSIONS (IN INCHES)
Height
Width
Depth
Depth including bumpout
Depth from back of case to front legs
OPTIONAL ACCESSORY TRIM KITS FOR GE MICROWAVE
OVENS (AVAILABLE AT ADDITIONAL COST)
For a custom built-in appearance, these kits allow built-in installation
of the countertop microwave oven into a wall or cabinet alone and are
U.L. approved for installation over a GE single electric wall oven.
These kits should not be installed over a gas wall oven.
ACCESSORY
TRIM KITS "Z"
30" Deluxe 29-3/4"
27" Deluxe 26-7/8"
NOTE: 120V, 60-cycle, grounded power receptacle location optional
on back within cabinet opening.
INSTALLATION INFORMATION: This information is not intended
to be used for installing unit described. Before installing, consult
installation instructions packed with product/kit for current
dimensional data.
For answers to your Monogram, GE Café
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center
21-3/16"
12-3/16"
21-3/16"
12-3/16" 12-3/16"
16"
20"
13"
PRODUCT DIMENSIONS PRODUCT DIMENSIONS
Height Height
Width Width
Depth Depth
Depth including bumpout Depth including bumpout
Depth from back of case to front legs Depth from back of case to front legs
MAX TRIM
HEIGHT KITS
19-1/8" JX9153SJ
19-1/8" JX9152SJ
™ Series, GE Profile
® Service, 800.626.2000.
20"
21-3/16" 16"
13"
12-3/16"
21-3/16"
16"
20"
13"
19-1/8"
Z
ACCESSORY TRIM KIT
JX9153
JX9152
™ Series or
20"
16"
A
13" C
Allow 3"
clearance
B
12-3/16"
21-3/16"
16"
20"
13"
*For ADA compliance, the microwave
must be installed no higher than 37".
CABINET OVERLAP REQUIREMENTS
CABINET OVERLAP REQUIREMENTS
A - Overlap of trim kit over top of cabinet
B - Overlap of trim kit over bottom of cabinet
A - Overlap of trim kit over top of cabinet
C - Overlap of trim kit over sides of cabinet
B - Overlap of trim kit over bottom of cabinet
NOTE:
C - Overlap of trim kit over sides of cabinet
Z
Allow an additional inch
of clearance beyond trim
29-3/4"
frame on all sides.
NOTE: Allow an additional 26-7/8"
inch of clearance beyond
trim frame on all sides.
23-1/8" ± 1/16"
17-1/16" ± 1/16"
18" MIN. receptacle
in cabinet 16" MIN.
receptacle outside
cabinet
36" MIN.*
30" 27"
30" 27"
1" 1"
1" 1"
1" 1"
3-5/16" 1-7/8"
1" 1"
3-5/16" 1-7/8"
Listed by
Underwriters
Laboratories
Specification Revised 3/16