Advertisement
DR-4524 Quick Installation Guide
Follow the installation, wiring, and connection instructions specified below before using
switching power supplies.
1. Installation
1.1 Mounting the power supply
a. Make sure the unit is properly ventilated.
b. Mounting the power supply into the DIN-rail track.
Admissible DIN-Rails: TS35/7.5 or TS35/15
b.1 Insert the upper end of the DIN-Rail clip into the back of the DIN-Rail track from its
upper side.
b.2 Pull down the plastic DIN-Rail lock and push the bottom of the DIN-Rail clip into the
track
b.3 Pull back plastic DIN-Rail lock and Check if the DIN-Rail clip is tightly attached on the
track
c. Make sure the unit has proper heat conduction. Do not cover the top and bottom wall
surface of the unit.
d. When you install two or more power supplies, leave enough space for cooling.
e. Forcing air over the unit will improve heat dissipation.
Air Outgoing
Incoming Air
1
Korenix Technology Co., Ltd.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Korenix DR-4524
- Page 1 Korenix Technology Co., Ltd. DR-4524 Quick Installation Guide Follow the installation, wiring, and connection instructions specified below before using switching power supplies. 1. Installation 1.1 Mounting the power supply a. Make sure the unit is properly ventilated. b. Mounting the power supply into the DIN-rail track.
- Page 2 Korenix Technology Co., Ltd. 2. Wiring and Connections 2.1 AC Power Input and DC Output wiring 2.1.1 Connecting to DC Output: Insert the positive and negative wires into the +V (Pin 6 or 7) and -V (Pin 4 or 5) terminal contact, tighten terminal screws to prevent DC Output wires from being loosened.
Need help?
Do you have a question about the DR-4524 and is the answer not in the manual?
Questions and answers