Koala Kare BCS User Maintenance And Cleaning Manual

BABY CHANGING STATION (BCS) MAINTENANCE AND CLEANING PROCEDURE
®
MAINTENANCE PROCEDURE
1. Prepare Area
Put on gloves. Place wet fl oor sign
outside restroom/facility door.
CLEANING PROCEDURE
1. Clean Exterior
Apply detergent with a spray bottle
or pre-moistened towel/rag to the
plastic portion of the exterior, careful to
avoid contact with the stainless steel
surface. Remove detergent with a dry
(microfi ber) rag. Apply disinfectant (with
a spray bottle/pre-moistened towel or
rag) on plastic portion of the exterior
and allow to air dry. Apply standard
stainless steel cleaner to the stainless
steel surface. With a soft rag, wipe with
the grain of the stainless steel surface to
remove.
2. Inspect Baby Changing Station (BCS)
Examine BCS exterior for dirt or soil.
2. Clean Interior
Open BCS. Unlock liner dispenser
and remove bed liners to avoid
contamination with detergent. Set aside.
Apply detergent (with a spray bottle/pre-
moistened towel/rag or brush) to BCS
bed surface, straps, and lower portion
of the back wall. Allow to sit (dwell) for
30 seconds, and then clean the bed,
straps and back wall area with a nylon
brush. Remove detergent with a dry
(microfi ber) rag. Apply disinfectant (with
a spray bottle/pre-moistened towel/rag
or brush) on the BCS bed, straps and
back wall and allow to air dry.
3. Inspect Door
Open and close BCS door. Shock
may need replacement if door opens
too rapidly or door doesn't close.
(Replacement parts can be found in
lower right inset.)
3. Replace Bed Liners
Replace/fi ll the bed liners behind elastic
cord. Lock liner dispenser. Close the
BCS, and apply the disinfectant (with a
spray bottle/pre-moistenedtowel/ rag or
brush) on the handle area again. Inspect
exterior to ensure no visible soil or
damage. (Inspect wall/fl oor below unit
to ensure it is free of soil or liquids.)
Koala Kare Products
4. Inspect Strap and Buckle
With door open, inspect strap for
wear and tear. Ensure buckle opens
smoothly and closes with a "click". If
belt is caught in BCS, unscrew, fi x and
reattach making sure the strap works
properly. Replace if necessary.
4. Wash Cleaning Supplies
Return cleaning equipment and wet
fl oor sign to the custodial closet. Wash
nylon brush and allow to air dry. Wash/
replace (microfi ber) rag and or towel
when soiled. Replenish detergent and
disinfectant containers. Check inventory
of bed liners (and alert Supervisor to
reorder if inventory is low.)
5. Warning Label
Inspect warning label. Replace if
missing or damaged. Close the BCS.
KB200-SS Replacement
Parts
885-KIT Strap Kit
473 Instructional Label
975 Warning Label- ASTM
Braille Label (optional)
199-KIT Shock Kit
465-XX-KIT Liner Lid Kit
466-XX-KIT Liner Dispenser Kit
476-SS Installation Kit
492-KIT Key
KB150-99 Bed Liners
481-KIT Bungee Cord
P/N 460 May 2012