Advertisement
High Rise Base for Model 77 Series
— Will also fit Greenlee
Model 77HRB
Operating, Safety and Parts Manual
This manual is free of charge. All personnel who operate this high
rise base should have a copy of this manual and read and understand
its contents. To request a copy, call or write to the address below.
CURRENT TOOLS • P. O. BOX 17026 GREENVILLE, SC 29606
800.230.5421 or 864.721.4230 • FAX 864.721.4232
*Greenlee
and 555
are registered trademarks of Greenlee/Textron.
®
®
77HRB
Electric Benders
®
Shown with Current Tools Model 77SE Single Shoe Bender
This manual should be read and understood by all personnel
who operate this high rise base. Failure to understand how to
safely operate this unit could result in injury or property damage.
This unit should only be operated by qualified personnel.
www.currenttools.com
Model 555
C Benders*
®
11/2017
Advertisement
Table of Contents
Related Manuals for Current Tools 77HRB
Summary of Contents for Current Tools 77HRB
- Page 1 To request a copy, call or write to the address below. CURRENT TOOLS • P. O. BOX 17026 GREENVILLE, SC 29606 800.230.5421 or 864.721.4230 • FAX 864.721.4232 www.currenttools.com...
-
Page 2: Table Of Contents
Follow ALL safety information provided by the manufacturer. WARNING CAUTION DO NOT stand on high rise base. DANGER WARNING CAUTION ONLY mount Current Tools Model 77 Electric Bender or DANGER Greenlee Model 555 C Bender to the high rise base.* ® ®... -
Page 3: Bender Mounting Instructions
BENDER MOUNTING INSTRUCTIONS 1. Install casters on the High Rise Base. The two rigid casters mount Rear on the front of the frame and the two swivel casters mount on the rear of the frame (See Figure 3A). 2. Remove all bending shoes and roller supports from the bender. - Page 4 CAUTION ALWAYS lock the two swivel locking casters when operating the bender. Item # Part # Qty. Description 77HRB-101 High Rise Base Electric Bender 451-25 Washer 77-025 Screw – Hx Hd Cap 1/2-13 × 1 1/4"...
-
Page 5: Roller Support Instructions For 1 1 ⁄ 2 " And 2" Emt Or Imc
Connector Connector Figure 5A Clamp NOTE: The two screws that go through the connector clamp need to be tightened onto the Current Tools ® engaging pedal. The third screw is only needed when mounting to a Greenlee roller support.* 1½" to 2"... -
Page 6: Linkage Arm Storage
5 ..77HRB-001 ..1 ..SCREW, SKT. SHOULDER – 3/8" × 3/4" 6 ..77HRB-002 ..1 ..SCREW, SKT. SHOULDER – 3/8" × 1" 7 ..77HRB-005 ..3 ..SCREW, HX. HD. CAP – 3/8-16 × 2 3/4" 8 ..77HRB-006 ..1 ..SCREW, SKT. SHOULDER – 3/8-16 × 1/2"...
Need help?
Do you have a question about the 77HRB and is the answer not in the manual?
Questions and answers