Subscribe to Our Youtube Channel
Related Manuals for Tactical technologies Joey Transcorder
Summary of Contents for Tactical technologies Joey Transcorder
- Page 1 The JOEY TRANSCORDER Synthesized Voice Transmitter PLUS Solid State Recorder All-in-one Package CTR-751/V OPERATING INSTRUCTIONS © Tactical Technologies Inc Rev 1c...
- Page 2 All-In-One Unit DESCRIPTION The Tactical Technologies Inc. Model CTR-751/V series ("Joey") is a 1 channel 1/2 Watt VHF-FM synthesized voice transmitter, combined with a solid state recorder. The transmitter and recorder combination ("Transcorder") requires 9 volts DC for its power supply, utilizes an external antenna for the transmitter, and a single microphone for both the transmitter and recorder operations.
- Page 3 TRANSCORDER OPERATION SETUP ATTENTION TO THE MARKINGS ON SMALL BATTERIES. WHEN USING THE FLYING LEAD CONNECTORS, THE 1.) Connect the external antenna to the CTR-751 by inserting the BLACK LEAD IS NEGATIVE AND THE RED OR WHITE male end of the SMC type antenna connector on the transmitter to LEAD IS THE POSITIVE.
- Page 4 JOEY'S VHF VOICE TRANSMITTER c.) Select "RUN" from the Start Menu d.) Type "a:\setup" in the white bar e.) Select "OK" f.) Follow the on screen instructions. INSTALLING YOUR TRANSMITTER SOFTWARE g.) Remove disk when finished. 1.) The computer program supplied to install the frequencies into your CTR-751 transmitter is a module written for Microsoft's PROGRAMMING YOUR TRANSMITTER OPERATING Hyper-Terminal.
- Page 5 Bar. units equipped with scrambling). b.) From the "Phone Number" tab, select your Com Port in the s..Selects SCRAMBLE transmission mode (for "Connect Using" pull down menu. Select the "Direct to Com units equipped with scrambling). ___" line that correlates to your Com Port. c.) Select "OK"...
- Page 6 The first available frequency to you is 150.0000 Mhz. The The computer will respond with "=1", as follows: second is 150.0125 Mhz. The third is 150.0250 Mhz. And so on through 173.9750, 173.9875, and 174.0000. Your frequency will always start with a "1" - so that is pre- 8.) The "1"...
- Page 7 input instruction, you can set the 'scramble' or 'clear' mode by Program a 0 or a 5, your next number must be a 0. Program a 1 or typing sv ("s" sets scramble mode, plus the "v" verifies the a 6, and your next number must be a 2. Program a 2 or a 7, your programming) or cv ("c"...
- Page 8 As you can see from the example, the frequency entered was 158.9685 MHz. This is invalid per the rules. The software responds with a comma, then 6 zeros, and a carriage return. At this point, the program has not updated your transmitter, and is awaiting an input instruction (f, v, c, or s) from you.
- Page 9 JOEY'S SOLID STATE RECORDER Running the Whisper Player software: The Joey's solid state recorder has been designed by Geonautics a. Click the START button. International, an Australian Company, who is widely known in the b. Select PROGRAMS electronic surveillance field for their well engineered devices. The c.
- Page 10 Once power is applied, the Joey and the software will 'handshake'. RECORDING AND PLAYBACK After about 10 seconds, the software will report that the Joey is ONLINE via the following response: $WSP, ONLINE. You will NOTE: If the REC programming/download cable is connected to the see this in the Whisper Player Communications Window found in Joey, recordings can only be initiated via the Whisper Player the lower left corner of the software screen.
- Page 11 Listing progress is reported in the Communications Window. a.) Sequential Number - each file on the recorder is given a 7.) If there are files on the device and they have not been number in sequence which serves two purposes. First, the unique downloaded, and you want to save these files, see the section on number gives individuality and identity to the file.
- Page 12 2.) The Joey's ID number - this number is unique to your Joey and select your CD-R drive for downloading). cannot be changed by you. This is NOT the Joey Transcorder Production Serial Number, but is a special number assigned to the 2.) Select the recording to be downloaded by left-clicking on the...
-
Page 13: File Number
File Integrity downloaded and saved recordings, or explore your computer to find other WAV files for playing. To ensure validity of the recorded data sets and to safeguard continuity of evidence, the Joey Recorder implements a number 2.) Double-click on the WAV file you wish to playback. The name of integrity checks. -
Page 14: Operating Notes
readily identified. Whisper Player Command Summary All this information is stored as part of the Geonautics' Audio Image (*.img) file and can be easily reconverted to a WAV file for Help - Whisper Help Display this help file Help - Version Joey hardware version information listening. - Page 15 Tactical Technologies Inc 1701 Second Ave PO Box 91 Folsom, Pennsylvania 19033 TEL: 610-522-0106 FAX: 610-522-9430...
Need help?
Do you have a question about the Joey Transcorder and is the answer not in the manual?
Questions and answers