Kohler Industrial Generator Set Operation Manual page 22

Analog Inputs Menu
This menu allows the user to review the settings. There
is one analog input that is programmer selectable if not
reserved by factory options.
There is an optional 2 input/5 output (I/O) module board
available that can provide two additional analog inputs.
The displays for analog inputs appear as shown below
with Values of 0--5 volts.
AIn A1 (analog input A1) standard
D
(reserved and not user programmable)
AIn A2 (analog input A2) standard
D
AIn B1 (analog input B1) with I/O module board
D
AIn B2 (analog input B2) with I/O module board
D
Changes to the Analog Inputs menu requires the use of
SiteTecht software.
Event Log Menu
This menu allows the user to review up to 1000 entries of
system events including shutdown faults, warning
faults, and status events. See 1.2.4 Controller Fault
Diagnostics for a list of the items that appear on the
Event Log.
22 Section 1 Specifications and Features
Volt Select Menu
Note: The generator set must be stopped before
changing the voltage selection.
This menu allows the user to readily change controller
voltage settings. The volt select feature is typically used
in towable or temporary applications.
Note: The volt select menu requires initial activation by
SiteTecht software.
select True to activate the volt select menu.
Note: The generator set output leads require voltage
reconnection if the generator set does not have a
voltage selector switch installed.
With the generator set stopped, go to the Volt Select
menu. Then push and hold the pushbutton/rotary
selector dial until the voltage selection starts to flash.
Volt selection is now available. Scroll to the desired
voltage and momentarily press the pushbutton/rotary
selector dial to confirm the voltage selection.
The displays for Volt Select appear as shown in the
following list.
120/240 V 1 Ph
D
120/208 V 3 Ph
D
139/240 V 3 Ph
D
277/480 V 3 Ph
D
120/240 V 3 Ph
D
In SiteTecht software,
TP-6694 7/18