Napoleon GZ550-1KT Installation Instructions

ELECTRICAL INSTALLATION TO BE DONE BY A QUALIFIED INSTALLER and must be connected and grounded in accor-
dance with local codes. In the absence of local codes, use the current CSA C22.1
current ANSI/NFPA 70
NATIONAL ELECTRICAL CODE
A junction box, receptacle and cover plate are necessary to complete this installation. Because some fi replace models may not
come equipped with one, a junction box specifi c for this application (part # W010-0482) may be ordered from your Wolf Steel /
Napoleon ® dealer.
This kit includes:
QTY. DESCRIPTION
1 Blower Assembly
1 Blower Bracket
1 Wire Harness
1 Thermodisc / Bracket
C W
1 Vibration Reducing Pad
2 Wing Nuts
2 Lock Washers
1 Variable Speed Switch
ALL MODELS (40 SERIES EXEMPTED):
The three slots on the mounting bracket allow ease of adjustment when attach-
ing the blower. For a quiet running blower, do not allow the assembly to sit on
the fi rebox base.
Slide the vibration reducing pad (A) into the clip (C) and up against the threaded
stud (B) at the other end. The blower must be able to be positioned entirely onto
the pad.
Tilt the blower assembly onto its side. Slide it past the controls and into the clip (C). Secure to the threaded stud using
the lock washer and wing nut provided. Ensure that the blower does not touch the fi replace base or the fi rebox.
Attach the connectors from the black and white wires to the thermodisc and secure the thermodisc bracket to the
securing stud at the bottom left of the unit using a lock washer and wing nut. Ensure that the thermodisc touches the
fi rebox wall.
GZ550-1KT BLOWER
INSTALLATION INSTRUCTIONS
in the United States.
PART #
GZ552
W080-0067
W750-0050
W010-0367
W361-0037
W450-0009
W735-0001
/ Knob KB-35
C W
CANADIAN ELECTRICAL CODE
If the fi replace was not previously equipped with a
blower: route a grounded 2-wire, 60hz power cable to
the junction box. At this point, it must be strain relieved
and insulated.
B
A
Continue with ALL MODELS
in Canada or the
C
W415-0135 / B / 01.11.07