Samsung ME16K3000AS Installation Instructions Manual page 21

C4. ADAPTING MICROWAVE
BLOWER FOR OUTSIDE BACK
EXHAUST (cont.)
3
. Carefully pull out the blower unit. The wires will
extend far enough to allow you to adjust the blower
unit.
BEFORE: Fan Blade
Openings Facing Forward
End A
4. Remove "Parts "A" with tin snips or pliers.
(On Some Model)
5
. Rotate blower unit counterclockwise 180°.
e Rotation
ck of
crowave
DE68-03587B-EN.indd 21
Step-by-step installation guide
End B
Parts "A"
Before Rotation
Back of
Microwave
After Rotation
Back of
Microwave
6
. Place the blower unit back into the opening.
AFTER: Fan Blade
Openings Facing Back
End B
CAUTION: Do not pull or stretch the blower unit
wiring. Make sure the wires are not pinched.
NOTE: The blower unit exhaust openings should
match exhaust openings on rear of microwave
oven.
7
. Replace the blower plate in the same position as
before with the screw.
8
. Attach the exhaust adaptor to the rear of the oven
by sliding it into the guides at the top center of the
back of the oven.
After Rotation
Push in securely until it is in the lower locking tabs.
Take care to assure that the damper hinge is installed
Back of
so that it is at the top and that the damper swings
Microwave
freely.
21
End A
2008-12-09 �� 4:13:17