Advertisement
Quick Links
Hardy Process Solutions sincerely appreciates your business. We encourage
input about the performance and operation of our products from our
customers. Should you not understand any information in this guide or
experience any problems with this product, please contact our Technical
Support Dept. at:
Phone: (858) 278-2900
Toll Free: 1-800-821-5831
FAX: (858) 278-6700
E-Mail: hardysupport@hardysolutions.com
Or visit our web site at:
http://www.hardysolutions.com
Proudly made in the U.S.A
PN 0596-0355-01 Rev. A
HI 1734-WS Quick Start Guide
HI1734-WS POINT I/O Weigh Scale Module is used for high quality front
end signal processing of load cells and load points (strain-gage type
sensors) for all types of industrial manufacturing weighing applications
through an Allen Bradley 1734 POINT I/O chassis.
This Quick Start Guide is designed for users of the HI 1734-WS module
that have a high degree of familiarity with Allen Bradley 1734 POINT I/O
systems and Hardy Process Solutions products. The Quick Start Guide
provides basic procedures for installing, configuring, and operating a
HI1734-WS POINT I/O Weigh Scale Module.
A complete Installation and Operation Manual can be found online:
www.hardysolutions.com, navigate to Products > PLC Weighing
Modules > Weight Modules> HI 1734-WS > Documents and Programs
Advertisement
Related Manuals for Hardy Process Solutions HI 1734-WS
Summary of Contents for Hardy Process Solutions HI 1734-WS
- Page 1 FAX: (858) 278-6700 E-Mail: hardysupport@hardysolutions.com Or visit our web site at: This Quick Start Guide is designed for users of the HI 1734-WS module http://www.hardysolutions.com that have a high degree of familiarity with Allen Bradley 1734 POINT I/O systems and Hardy Process Solutions products. The Quick Start Guide Proudly made in the U.S.A...
- Page 2 INSPECTED AND CAREFULLY COMPARED WITH THE SHIPPING DOCUMENTS. IF ANYTHING IS UNSATISFACTORY, PLEASE NOTIFY HARDY IMMEDIATELY BY CALLING, FAXING OR E-MAILING TO: Customer Support Department HARDY PROCESS SOLUTIONS 9440 Carroll Park Drive, Suite 150 San Diego, California 92121 Phone: (800) 821-5831...
-
Page 3: Installation Procedure
Installation Procedure Common Terms AOP: Add-On-Profile. Auto-Zero: Automatic zeroing of the scale as the gross weight nears its last zero point, subject to the cumulative limit of the Zero Tolerance parameter. Auto-Zero Tolerance is how much the Auto-Zero function can adjust at one time. C2®: C2®... - Page 4 1) Verify that the Reference Weight and Span Weight have been set correctly in the configuration tab. The HI 1734-WS weigh scale module is connected to external load cells 2) If Reference Weight=0, remove all weight from the scale. or sensors using the terminal blocks. A single sensor can be connected 3) Click Low CAL to set the low point on the calibration curve.
-
Page 5: Initial Setup
1) Select Waversaver setting Flashing Red Read Convert Error 2) Input Num Averages See HI 1734-WS Installation & Operations Manual for Calibration Settings troubleshooting procedures related to Steady or Flashing Red LEDs 1) Select Load Cell Sensitivity 3. Set-up communications between the ControlLogix PLC and the 2) Input Gravity Corr. - Page 6 AOP (i.e.: those made in Ladder Logic or via a Faceplate). 8. Optional Faceplates and Add-On-Instructions for the HI 1734-WS module are available on the Hardy Process Solutions website under...