Safety Warnings - LG ARUN050GSS0 Owner's Manual

Safety Warnings

1
• Contact your dealer, sales representative, an authorized
electrician or an authorized service center for electrical
work on this unit.
• Always contact with your dealer or an authorized service
center for installation.
• Always ground this unit.
• Always use circuit or breaker dedicated to this unit.
• Contact with your dealer or an authorized service center
for the installation, removal or re-installation of this unit.
• Never try to install, remove or re-install this unit by your-
self (customer).
• Do not store or use flammable material or gases in the
vicinity of the unit.
• Use a circuit breaker or fuse with correct rating.
• Install the unit to a proper place that it will not be dam-
aged due to a storm, typhoon or an earthquake.
• Do not install the unit on a damaged installation pad.
• Do not charge the unit with refrigerant other than the re-
frigerant specified on the unit during the installation or
transportation of the unit.
• Do not change the settings of the safety equipment after
the unit is installed.
• Ventilate the room before operating the unit when there
is a gas leak.
• Install the cover of the control box and front panel care-
fully.
• Check if the refrigerant concentration is within the safety
limits when there is a gas leak while operating the unit
in small, enclosed areas preventing proper ventilation of
the area.
OPERATION
• Do not make modifications or extensions to power cord.
• Always use circuit or breaker dedicated to this unit.
• Be careful to prevent water ingress to the unit.
• Do not touch (operate) with wet hands.
• Do not store or use flammable material or gases in the
vicinity of the unit.
• Do not put your hand inside the air inlet or outlet during
installation of the unit.
• Make sure that no one steps on the outer unit or fall on
it.
• Do not put your hand or other things inside the air inlet
or outlet during the operation of the unit.
WARNING
INSTALLATION
• Always check for refrigerant leak after the installation or
maintenance of the unit.
• Always hold the unit straight even when you are in-
stalling it.
• Do not install the unit to a place where the noise and air
coming from the outer unit may cause harm to the
neighbors.
• Use a proper power cord.
• Do not use the unit for special purposes as to protect
the food or art pieces. This is not a delicate cooling sys-
tem, just a general purpose air conditioner.
• Keep the unit away from children. Heat exchanger sur-
faces are very sharp.
• Use noise dampening equipment when the unit is in-
stalled at hospitals or libraries.
• Do not install the unit to places open to direct sea wind
(salt spraying).
OPERATION
• Do not use the unit on special environmental conditions.
• Do not prevent inlet or outlet of the air flow.
• Ensure that the power cord is not pulled or damaged
during the operation of the unit.
• Ensure that the installation area is not deteriorated in
time.
• Connect the water drainage hose correctly (by using
isolation) during the installation of the unit.
• Be careful during the transportation of the unit.
• Be careful when you are unpacking and installing the
unit.
• Supply power to the unit minimum 6 hours before op-
erating it.
• Do not touch the refrigerant hoses during or after the
operation of the unit.
• Do not operate the unit with the front cover or control
box removed.
• Do not cut power supply immediately after turning off
the unit.
• Perform the automatic addressing after connecting the
power and communication cords of the inner and outer
units. Automatic addressing shall also be performed
when the electronic board of one of the inner units is re-
placed.
• Use a stable stool or ladder when you are cleaning or
maintaining the unit.
• Ensure that the installation area is not deteriorated in
time.
4 | EN