Page 2
Connect the LauncherOne to the NovoConnect device. NOTE: The NovoConnect device must be powered on and connected to a display. Loading... The main button on the LauncherOne lights up red and a Loading screen is shown on the display.
Page 3
Pairing Completed SSID: IP Address: Wait for the main and corner buttons on the LauncherOne to light up blue and the Pairing Completed screen to be shown on the display. Connect the LauncherOne to a computer and the LauncherOne software will run automatically.
Page 4
Wait for the main button on the LauncherOne to light up red, and then press the button. Your computer’s screen is shown on the display.
Page 5
Press any corner button on the LauncherOne to project your computer’s screen onto the corresponding quadrant of the display.
ADDITIONAL INFORMATION Safety & Warning Information FCC - Federal Communication Commission (USA) This device contains the following wireless device and underwent the certification process of FCC Part 15 Subpart B / CISPR 22 ET Docket No. 95-19 under the respective FCC ID Below: • FCCID: H79ESSQL-300 The FCC ID is indicated as the label affixed on the bottom side of your device.