Philips NTX400 Short User Manual page 2

Store radio stations automatically
FM/AM
PROG
AUDIO IN
AUDIO IN
REC
DISC
Record from a disc to a USB device
•
To record one track in a disc: select a track to
play, then press USB REC.
•
To record all tracks in a disc: press
then press USB REC.
• To stop recording, press
Note: With MP3-CD playback, you can only record all
tracks in the current folder.
Set clock
1
In standby mode, press and hold CLOCK for
two seconds.
2
Press
hour format.
3
Press CLOCK
»
4
Repeat steps 2 to 3 to set the hour and minute.
Standby
CLOCK SET
NTX400_79_SUM_V1.0.indd 2
FM/AM
When entering FM or AM mode for the
AUTO INSTALL-PRESS
search and store all the available radio
PLAY-STOP CANCEL
stations. Then press to start full scan.
AUTO
MHz
MHz
FM/AM
You can also press and hold PROG
for two seconds to activate automatic
AUTO
programming.
MHz
MHz
SLEEP OFF 120MINS
15MINS
to stop play,
.
/ repeatedly to select 12 hour or 24
Set the timer
TIMER SET
Note: Make sure that clock is set correctly.
1
In standby mode, press and hold TIMER for two seconds.
2
Press / repeatedly to select a sound source: DISC, USB,
DISC/USB/FM/AM
FM, or AM.
3
Press TIMER
4
Press / to select 12 hour or 24 hour format.
5
Press TIMER
In 12 hour format, [AM] or [PM] is displayed. Repeat
»
»
6
of the sound source.
TIMER ON
If the product is in standby or Eco power standby
»
mode, the selected sound source will be activated when
the preset time comes.
TIMER OFF
Tune to FM/AM radio stations
FM/AM
Search
MHz
FM/AM
Note:
• You can program a maximum of 20 FM and 10 AM radio stations.
•
To overwrite a pre-stored station, store another station in its place.
MHz
AUX DVD AUX TV
DVD
L
R
90MINS 60MINS
30MINS 45MINS
1
Turn on the product.
2
Press SLEEP repeatedly to select a period of time
» This product switches to standby mode
automatically after the preset time period.
When [SLEEP OFF] is displayed, the sleep
»
timer is deactivated.
Total Output Power
Frequency Response 60 -20000 Hz, ±3 dB
Signal to Noise Ratio
Disc
Audio DAC 24 Bits / 44.1 kHz
Frequency Response
Speakers
Speaker Impedance 3 ohm
Sensitivity
Tweeter: 88± 3dB/m/W
Tuner
Tuning Range
Tuning Grid
Number of Presets 20 FM, 10 AM
Bluetooth
Bluetooth Version V4.0 + EDR
Bluetooth Frequency Band 2.402GHz ~ 2.48GHz ISM
Band
A2DP, AVRCP V1.4
Range
General information
AC Power
Standby Power 30 W
Consumption
Eco Power Standby < 1 W
Consumption
USB Direct
Headphone Output
Operating Temperature and
Humidity humidity for all climates
Dimensions - Main Unit
Weight - Main Unit 13 kg
Store FM/AM radio stations manually
MHz
P 01
PROG
P 02
02
MHz
PROG
Button
+ VOL-
EQ
DBB
NX BASS
(on the main
Warranty against Defects
In this warranty:
We or us means Gibson Innovations ARBN 165 105 975 , and our contact details are set out at the end of this
warranty;
You means the purchaser or the original end-user of the Goods;
Supplier means the authorised distributor or retailer of the Goods that sold you the Goods in Australia or New
Zealand; and
Goods means the product or equipment which was accompanied by this warranty and purchased in Australia or New
Zealand.
If you require assistance with the operation of the product, its features or specifications please call the Philips
Consumer Care Centre on 1300 850 633 in Australia or 0800 639 953 in New Zealand.
Australia: Our Goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are
entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss
or damage. You are also entitled to have the Goods repaired or replaced if the goods fail to be of acceptable quality
and the failure does not amount to a major failure. This is not a complete statement of your legal rights as a consumer.
New Zealand: Our Goods come with guarantees that cannot be excluded under the Consumer Guarantees Act 1993.
This guarantee applies in addition to the conditions and guarantees implied by that legislation.
Additional Warranty:
In addition to the rights and remedies that you have under the Australian Consumer Law, Consumer Guarantees Act
of New Zealand or any other applicable law, we provide the following warranty against defects:
1. If, during the first 12 months from their date of purchase from the Supplier (Warranty Period), the Goods prove
defective by reason of improper workmanship or materials and none of your statutory rights or remedies apply, we
will repair or replace the Goods without charge.
2. We do not have to repair or replace the Goods under this Additional Warranty if the Goods have been used for a
commercial purpose; misused, improperly or inappropriately installed, operated or repaired; abused; damaged; or
not maintained in accordance with the manufacturer's instructions.
3. Even when we do not have to repair or replace the Goods, we may decide to do so anyway. In some cases, we
may decide to substitute the Goods with a similar alternative product of our choosing. All such decisions are at
our absolute discretion.
4. All such repaired, replaced or substituted Goods continue to receive the benefit of this Additional Warranty for the
time remaining on the original Warranty Period.
5. This Additional Warranty is limited to repair, replacement or substitution only. As far as the law permits, we will not
be liable for any loss or damage caused to property or persons arising from any cause whatsoever.
6. In order to claim under this Additional Warranty you must telephone us on 1300 850 633 in Australia or 0800 639
953 in New Zealand within the Warranty Period. You will be asked for details of the Goods, a description of the
defect and your personal details. Upon accepting your claim, we shall assist you with either returning the Goods to
the Supplier for replacement or to the most convenient Philips Authorised Service Centre for your Goods to be
repaired. In some case we may require that you return to the Goods to us (at the address below) for repair,
replacement or substitution.
All returned Goods must be accompanied by satisfactory proof of purchase which clearly indicates the name and
address of the Supplier, the date and place of purchase and identifies product. It is best to provide a legible and
unmodified receipt or sales invoice.
You must bear any expense for return of the Goods or otherwise associated with making your claim under this
Additional Warranty.
7. This warranty is only valid and enforceable in Australia and New Zealand.
Contact us or the place of purchase for further details.
Australia
Gibson Innovations
Suite 22a 33 Waterloo Rd
Nth Ryde, NSW 2113
Consumer Care: 1300 850 633
E-mail: pccw.woox@gibson.com
Website: www.philips.com/support
Select a preset FM/AM radio station
01
MHz
02
20
Function
Increase or decrease volume.
Mute or resume sound.
Select a preset sound effect: POP, PARTY, ROCK,
REGUETON, or HIP-HOP.
Turn the dynamic bass enhancement on or off.
Apply NX bass effect.
New Zealand
Consumer Care: 0800 639 953
Email: pccw.woox@gibson.com
Website: www.philips.com/support
Apr 2015
7/29/2015 4:19:44 PM