Advertisement
Selecting Channels to Display
1. Launch LogWorks from your iPhone or iPod touch.
2. Press the LogWorks tab.
3. On the upper left-hand corner you will see a
to enter the configuration screen.
4. The configuration screen has three parameters to configure:
Imperial Units: Allows you
to select Imperial Units or
Metric
Lambda or AFR: If there
is any Innovate
Motorsports A/F meter
connected to the OT-2
you can chose to display
the channels as AFR or
Lambda.
Gauges: Chose which
channel to display on the
gauge. Note: Channels
available for display must
be enabled from the OT-2
tab first.
5. Press Done on the upper right hand corner when done
configuring.
icon, press it
Order parts, get support, find FAQ answers, and read case
< (10-2303.B)
OT-2
QUICK START GUIDE
The complete instruction manual is on the CD
studies at www.tuneyourengine.com
11-0126
Advertisement
Table of Contents
Summary of Contents for Innovate OT-2
-
Page 1: Quick Start Guide
Gauges: Chose which channel to display on the gauge. Note: Channels available for display must be enabled from the OT-2 tab first. 5. Press Done on the upper right hand corner when done configuring. Order parts, get support, find FAQ answers, and read case studies at www.tuneyourengine.com... - Page 2 App Store. A search for “LogWorks” will yield results for the application. Once installed you (Note: If you receive an error code indicating that the OT-2 hardware should see the LogWorks icon. was not found go back to network configuration instructions and verify there is a check mark next to the INNOVATE_XXXX network.)
Need help?
Do you have a question about the OT-2 and is the answer not in the manual?
Questions and answers