BN68-00597A-01
4/2/04
ENG
Rear of the PDP
Rear of the PDP
Satellite receiver/
Decoder
6:38 PM
Page 12
Connecting to an Aerial or Cable Television Network
To view television channels correctly, a signal must be received by
the set from one of the following sources:
1
2
or
Cable Television
Network
Connecting a Satellite Receiver or Decoder
In order to watch television programmes broadcast via a satellite
network, you must connect a satellite receiver to the rear of the
PDP. Also, in order to descramble a coded transmission signal, you
must connect a decoder to the rear of the PDP.
Using a Coaxial cable
or
12
An outdoor aerial
A cable television network
A satellite network
In the first three cases, connect the aerial or network input cable to
the 75Ω coaxial socket on the rear of the PDP.
If you are using an indoor aerial, you may need to turn it when
tuning your PDP until you obtain a picture that is both sharp and
clear.
For further details, refer to:
"Storing Channels Automatically" on page 18
"Storing Channels Manually" on page 19
When installing or re-installing your PDP, be sure to use the
supplied coaxial antenna cable. If you connect using a different
coaxial cable, there is risk of noise or interference to the screen
image. (You must not use another general purpose cable.
Use the 3M/5M/7M cable supplied by Samsung.)
Connect a coaxial cable to the:
Receiver (or Decoder) output socket.
Television aerial input socket.
If you wish to connect both a satellite receiver (or decoder)
and a VCR, you should connect the:
Receiver (or Decoder) to the VCR
VCR to the PDP
Otherwise, connect the receiver (or decoder) directly to the
PDP.