Related Manuals for Living Earth Contour
Summary of Contents for Living Earth Contour
- Page 1 INSTALLATION MANUAL Contour Pedicure Line Contour Contour LX 1-400-00XX • Rev A • X/X/XX *shown with optional accessories and/or finishes © Living Earth Crafts 2017, All Rights Reserved...
-
Page 2: Table Of Contents
Introduction Congratulations on your purchase of the Contour pedicure chair. This manual is designed to be given to the licensed plumbers, electricians, and any other technicians performing the installation of your pedicure chairs. Installer(s): Please review this manual in detail before beginning installation, and follow all safety warnings, labels, and instructions. -
Page 3: Section 1: Safety Information
Avoid positioning the cord in the traffi c lane and it is always kept out of the way. Read all instructions before using the Contour pedicure chair. Take this furnishing out of service immediately if the cord or plug becomes damaged in any way. -
Page 4: Section 2: Product Overview
SECTION 2 : PRODUCT OVERVIEW SECTION 2 : PRODUCT OVERVIEW Product Specifi cations Pillow Overall Width 32.5” (78.7 cm) Shroud Width 22” (55.8 cm) Backrest Cushion Shroud Height 15” (38.1 cm) Seat Cushion Length (armrest doors open) 73” (185.4 cm) Side Tray Length (armrest doors closed) 57”... -
Page 5: Section 3: Installation
SECTION 3 : INSTALLATION SECTION 3 : INSTALLATION Installation Summary Recommended Spacing NOTE: INSTALLER/OWNER BEARS ALL RESPONSIBILITIES TO COMPLY WITH ALL STATE AND Option 1 - Standard LOCAL CODES FOR PLUMBING AND ELECTRICAL WHEN INSTALLING THIS PRODUCT. FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY VOID WARRANTY. 32.5”... - Page 6 Use this opti on if your hot and cold water supply and drain line will be located in a fl oor the Contour. Cutti ng off the end of the electrical plug to hardwire the spa is NOT recommended, sink underneath the Contour. For this opti on, there are several added steps to make the and can void the warranty.
-
Page 7: Backflow Prevention
Backflow Prevention Backflow Prevention Each Contour comes with a dual backflow preventative device pre-installed. This device utilizes two (2) 15mm check valves that are certified to ANSI/NSF 61 and ASME A112.18.3 (see detailed specification from manufacturer on the next page) The ASME A112.18.3 standard, in Section 8.1.1, indicates that “there shall be at... -
Page 8: Initial Assembly
Washer Washer Hex Nut 1. Attach Seat Back The Contour seat back is shipped detached in order to minimize shipping costs and Shoulder damage. Follow the diagram below to attach each side of the seat back to the frame. Bolt... -
Page 9: Electrical Specifications
Flow Rate (120V) 24 l/min at 0, 1 bar Warranty Information Living Earth Crafts (LEC) offers an industry best warranty against defects in materials, design, Flow Rate (220V) 20 l/min at 0, 1 bar and workmanship, to the original owner, as follows: •... - Page 10 Notes...
-
Page 11: Contact Us
Contact Us Living Earth Crafts Hours of operation: 3210 Executive Ridge Monday - Friday Vista, CA. 92081 8:00 a.m. to 5 p.m. PST (800) 358-8292 (760) 597-2155 Int’l Saturday - Sunday (866) 449-8872 fax Closed info@livingearthcrafts.com Visit us online at: livingearthcrafts.com Read our blog at: livingearthcrafts.com/blog...