Summary of Contents for Adastra DP-8
- Page 1 DP-8 DIGITAL POWER SCHEDULE CONTROLLER Item ref: 953.058UK User Manual Version 1.0...
- Page 2 Introduction Thank you for choosing an Adastra DP-8 digital power schedule controller for power automation of installed sound, lighting and service equipment. This unit is designed to provide flexible scheduling and automation of 8 power outlets, fully programmable by the operator.
- Page 3 The DP-8 may not be suitable for powering from other equipment which may be sensitive to an inductive load, such as a DC inverter. The maximum total load at any time is governed by the main circuit breaker (1) or mains fuse if the DP-8 is powered from a UK plug.
- Page 4 Powering up When all connections are made, with the main circuit breaker (1) in the “OFF” position, connect power to the DP-8. Switch the power supply on and power up the DP-8 by switching the main circuit breaker to the “ON” position.
- Page 5 The alarm can be stopped by pressing the ESC or Lock button. A further maximum voltage value can be stored in the DP-8, above which the 8 outputs will cut out. An alarm current value can also be stored in the DP-8, above which an audible alert is activated.
- Page 6 Exit the menu and press the On or Off button to trigger the relative stored sequence. Initialization To reset the DP-8 to initial factory settings, in the settings menu, step through the options until “INIT” is displayed and press “Enter”. The display will show “INIT N”, where “N” denotes “No”. Use the +/- buttons (8) to set to yes and press Enter.
- Page 7 Specifications Power supply 110-230Vac, 50/60Hz (hard-wired) Current max. 32A total Contact rating 10A max. for any output Time setting Day(s), hours, minutes, seconds Internal programs 99 schedule scenes, auto power sequence Outputs 8 x IEC power outlets Connections USB port, RS485, 12Vdc out, remote, GND, Status Dimensions 482 x 250 x 44mm Weight...
Need help?
Do you have a question about the DP-8 and is the answer not in the manual?
Questions and answers