Scout URC-21 Series Manual

Scout URC-21XXX/23XXX Remote
The Scout remote is designed to operate all of the features of our cable box and the
most commonly used features from TVs: Volume Control, Mute, and Power. It's
preset to your cable converter and has preprogrammed technology for easy setup.
It's also guaranteed to operate all infrared remote controllable televisions
manufactured for the U.S. market.
The SETUP button is used to program Scout.
The TV and CBL buttons are used to power on your TV and cable converter
respectively.
The VOL UP/DWN and MUTE buttons are used to control the volume of your
TV or cable converter.
The CH UP/DWN buttons are used to change the channels on your cable
converter.
The Number buttons (0 - 9) are used for directly accessing the channels on
your cable converter.
The LAST button returns you to the previously viewed channel on your cable
converter.
The FAV button accesses the favorite channels stored into your cable
converter. For instructions on setting up a Favorite Channel table, refer to
your cable converter manual.
The CABLE INTERACTIVE buttons, (at the bottom of the remote) control the
functions of your cable converter and will vary depending on the
manufacturer of your cable converter. Refer to your cable converter manual
for button descriptions.

Installing the Batteries

Setting Up Your Scout To Operate Your Tv
Searching For Your Television Code
Getting Codes From Your Scout
Volume Lock
Troubleshooting
Installing the Batteries
The Scout requires four new AAA alkaline batteries.
1. On the back of the Scout, pull back on the tab and lift off the battery cover.
2. Match the + and - marks on the batteries to the ones in the battery compartment of the remote.
3. Press the battery cover back into place.
4. Test the remote control by pressing the TV button. If the batteries are installed correctly, the red
light on the remote will blink once.
Back to Top