Advertisement
Quick Links
www.nkrowing.com.au
Wiring Installation Instructions &
Troubleshooting
NIELSEN-KELLERMAN
206 Cowans Lane, Oxley Island NSW 2430
web: www.nk.com.au
Email: info@nk.com.au
Phone: 02 6553 2476
Fax: 02 6553 2544
Thank you for purchasing this StrokeCoach wiring system. PLEASE take a moment to
review these instructions before installing the wiring harness. Your StrokeCoach system should
provide you with years of trouble-free service but we are always here to help if a problem arises.
To order parts or accessories or obtain technical support, please call 02 6553 2473 You may also
e-mail orders to info@nk.com.au and send questions to our support representatives at
info@nk.com.au You can also visit us on the web: www.nk.com.au
If you've never done this before, please read through all of these
installation instructions before permanently installing any part of your
StrokeCoach System.
The VHB ("Very High Bond") mounting tape used in this installation
requires 24 hours to cure to its full bond. PLEASE avoid getting it wet (in
other words, don't take your boat for a row) until fully cured. Failure to do
this risks having to re-install parts of your system.
Wherever you will be installing VHB mounting tape, make sure to use
the provided alcohol swabs to clean all oil and dust from the mounting
surfaces. Avoid touching the VHB with your fingers as the oil on your skin
decreases the bond strength.
IF you ever need to remove installed VHB, use a hair dryer to warm the
VHB thoroughly, then peel very slowly from one edge to avoid damag ing
the surface.
1
Advertisement
Related Manuals for Nielsen-Kellerman StrokeCoach
Summary of Contents for Nielsen-Kellerman StrokeCoach
-
Page 1: Troubleshooting
Phone: 02 6553 2476 Fax: 02 6553 2544 Thank you for purchasing this StrokeCoach wiring system. PLEASE take a moment to review these instructions before installing the wiring harness. Your StrokeCoach system should provide you with years of trouble-free service but we are always here to help if a problem arises. - Page 2 SELECTING AN INSTALLATION LOCATION AND MOUNTING BRACKET It's a good idea to think about where you want your StrokeCoach while you are sitting in your boat. Your mount- ing location should allow you to see the unit clearly and reach the button, but still keep the unit out of the way of your hands, oar handle or paddle throughout the stroke.
- Page 3 Slide the StrokeCoach display unit onto the docking station until it clicks. Be sure that the lanyard is out of the way. NOTE: To prevent the loss of your StrokeCoach in the event that it is bumped while you are rowing, loop the lanyard around the top of the T-bracket or some part of your shell and slip the StrokeCoach through the loop.
- Page 4 1/2 Distance the center of the seat travel. If the sensor is too close of Seat Travel to either end of the seat travel, the StrokeCoach may indicate ONE-HALF the correct stroke rate. Sensor The vertical spacing between the stroke sensor...
- Page 5 www.nkrowing.com.au Check that the sensor cable is routed conveniently before mounting the sensor. You can install the sensor and magnets semi-permanently by using the 3M VHB (Very High Bond) tape supplied. Should you wish to make a temporary installation, use electrical tape to affix the sensor. Use the alcohol prep pad provided to clean the area of the deck to where you will attach the sensor.
- Page 6 (with the same stroke-mode setting your unit) on your dock station. The fellow rower should use your StrokeCoach (with the same settings) on his or her docking station. This will allow you to determine if the control unit or the docking station is at fault.
- Page 7 www.nkrowing.com.au Making Work & Play & & & & & & & & & & & Easier & Safer & & & & & & & & & & & & & & & & & & & & & &...
-
Page 8: Contact Info
www.nkrowing.com.au Contact Info: Delivery Address (Please send all parcels to this address) Nielsen Kellerman Australia Pty Ltd 206 Cowans Lane Oxley Island NSW 2430 AUSTRALIA Email: info@nk.com.au Web: www.nk.com.au Phone: 02 6553 2473 Fax: 02 6553 2544 NK Rowing Electronics Warranty & Service NK does not believe in "disposable electronics."...