Identification Of Controls - NAD D 3045 Owner's Manual

1 o (STANDBY)
•
With the corresponding end of the mains power cord connected
to the AC mains input of the D 3045 and the plug connected to a
mains power source, press o (Standby) to switch ON the D 3045
from standby mode. The Standby indicator will turn from amber to
bright color.
• Press and hold o (Standby) until D 3045 switches back to standby
mode.
2 VOLUME
•
Rotate Volume knob clockwise or counterclockwise to adjust audio
level.
•
Rotating the Volume knob will automatically restore audio from
mute mode.
3 SOURCE
•
Rotate clockwise or counterclockwise to select desired Source.
4 DISPLAY
•
Sources, audio level and other indicators are shown.
• Display follows the orientation of the unit - vertical or horizontal
view.
IMPORTANT NOTE
Display will temporarily turn off if there is no user interface interaction
within 5 minutes. Restore display by sending a remote control command
or rotating any of the controls.
5 PHONES
• Use the 3.5 mm stereo jack socket for headphone listening.
•
Specially designed low noise headphone circuitry can accommodate a
wide range of phones, even 600 Ohm studio models.
•
Adjust headphone audio level by rotating the VOLUME control
clockwise or counterclockwise.
•
Ensure that the volume control is turned to minimum (fully
counterclockwise) before connecting or disconnecting
headphones. Listening at high levels can damage your hearing.
•
Inserting a headphone jack into this socket automatically switches
off the loudspeakers.

IDENTIFICATION OF CONTROLS

6 7 8 9
1
PHONO
LINE 1 LINE 2
(MM)
COAXIAL
2
OPTICAL 1 OPTICAL 2 COMPUTER
11
3
4
5
6 GROUND TERMINAL
•
If a separate earth ground is necessary, use this terminal to
ground your D 3045. The D 3045 can be connected to ground by
connecting a ground lead wire or similar to this terminal. After
insertion, tighten the terminal to secure the lead.
NOTES
• Consult with a licensed electrician to properly locate or correctly
install a grounding conductor in your home. NAD is not responsible
for any malfunction, damage or costs associated with the installation,
connection or grounding of your D 3045.
• The grounding wire is not supplied with your D 3045.
7 PHONO (MM)
•
Input for a Moving Magnet (MM) phono cartridge only. Connect the
twin RCA lead from your turntable to this input if you are using a
Moving Magnet cartridge.
8 LINE 1
•
Connect to corresponding analog output of other audio devices
using a 3.5mm stereo plug to RCA connector adapter (not
supplied).
9 LINE 2
• Connect to corresponding analog output of a CD player,
preamplifier, processor or other applicable devices using RCA-to-
RCA stereo cable (not supplied).
10
PRE / SUB
OUT
HDMI
ARC
+12V
TRIGGER
IN
12 13 14 15
100-120V~60Hz / 220-240V~50Hz
16 17
5