Led Status; Speaker Phone Functions - Gear4 StreetParty Wireless User Manual

■ Ensure that your StreetParty Wireless is fully
charged or is connected to a power source
and is switched ON.
■ Press and hold the
at the front of the speaker starts flashing.
(The speaker will have 10 minutes to
connect/pair with your device.)
■ 'Gear4 SPW' will appear on your
Bluetooth device.
■ Select 'Gear4 SPW' and enter the
password '0000' if necessary.
■ The LED will stop flashing when your device
has successfully paired.
Note: StreetParty Wireless can only be paired to
one electronic device at any given time.
For use with
other audio devices:
■ Plug one end of the 3.5mm audio cable
(supplied) into your personal electronic
device and connect the other end into the
AUX IN port at the back of the speaker.
Note: Speaker volume cannot be adjusted using
the speaker volume controls
Speakerphone functions:
■ To answer a call – press the
■ To reject a call – press and hold the
button for 1 second.
button until the LED
button
■ To end a call - press the
■ To switch call signal between speaker and
phone - press the Audio Source icon
displayed on the iPhone screen (when a call
has been initiated).

LED Status:

LED SyNC INDICaTOr (FrONT):
■ Power OFF – LED OFF
■ Power ON – LED ON (blue)
■ Pairing Mode – LED FLASHING (blue/red)
LED CharGING INDICaTOr (BaCK):
■ Fully Charged – LED ON (red)
■ When Charging – LED ON (blue and red
together)
Register your StreetParty Wireless to activate
your warranty and receive product updates at
www.gear4.com/register
Copyright © 2012 Disruptive Limited. All rights
reserved. Reproduction in part or in whole is
prohibited. GEAR4 and StreetParty are trade
marks of Disruptive Limited. iPad, iPhone, iPod
annd iPod touch are trade marks of Apple Inc.,
registered in the U.S. and other countries. App
Store is a service mark of Apple Inc.
The Bluetooth word mark and logos are
®
registered trademarks of Bluetooth SIG, Inc.
User Manual | StreetParty Wireless | GEAR4
button.
3