UniData Communication Systems Neon 3016A Manual page 15

Manual – 3000 NRL Family
3.3.2 Communication Parameters
Config Comms
Logger
...press Down
Status
Scheme
Status
Configure
Logger
Parameter
Force Neon comms
Initialise NRL
NRT ID
Set Neon IP
Ethernet priority
3G/4G SIM1 priority
3G/4G SIM2 priority
Serial (Satellite) priority
Serial (X-Bee) priority
Set SIM1 APN
Set SIM1 User / PW
Set SIM2 APN
Set SIM2 User / PW
Set Satellite APN
Set Satellite User/PW
Set Ethernet IP
Set Ethernet Netmask
Set Ethernet Gateway
Set Ethernet DNS
WiFi SSID
WiFi Password
LoRa Mode
Unidata Manual - 3000 NRL Family - 17 09 2018.docx
Notes
Force a communications cycle to occur immediately instead of at
the scheduled time.
Connects to the Neon Server, downloads the scheme for the
configured NRT ID, and starts logging.
A number assigned by the Neon Server that identifies the NRT /
NRL. Ranges from 1 through 4,294,967,295.
The IP address of the Neon Server.
These parameters set the communications priority for the various
communications interfaces.
A higher number indicates a higher priority.
A priority of '0' indicates the interface is not used.
Access Point Name and corresponding Username and Password
for the SIM1 / SIM2 / Satellite communications interfaces. Access
Point Names must be in double-quotes (") otherwise the setting will
be treated as a telephone number to connect to.
Static IP address. Set any of this, Gateway or DNS addresses to
0.0.0.0 for DHCP.
Default 255.255.255.0
Static Gateway IP address. Set any of this, IP or DNS addresses to
0.0.0.0 for DHCP.
Static DNS IP address. Set any of this, IP or Gateway addresses to
0.0.0.0 for DHCP.
WiFi SSID / Password & LoRa Network ID / Key
ABP(default) or OTA
Page 15