Related Manuals for Cambro PRO CART ULTRA
Summary of Contents for Cambro PRO CART ULTRA
- Page 1 OWNER’S CAMBRO PRO CART ULTRA ® ™ MANUAL This owner's manual applies to all electric and non-electric models that begin with the prefix PCU. www.cambro.com...
-
Page 2: Table Of Contents
™ new insulated transporter – versatile enough to hold hot or cold food. If you have any further questions, please contact your Cambro Sales Representative, visit www.cambro.com or call our Customer Service Department at 800.833.3003 (International customers please call 1.714.848.1555). -
Page 3: Rail Installation And Capacity Guide
III. Rail Installation and Capacity Guide (continued) 18" x 26" (45,7 x 66 cm) Full Size Sheet Pans TIP: It is easier to start rail installation from the bottom and move up. 1. Using the chart on page 2, select the type of holding you would like to achieve. Follow the number guides etched into the columns of the cart to place your sheet pan, food pan, tray or pizza box in the correct position. -
Page 4: Instructions For Security Package (S) Models
1. From any PCU module, plug into 100-120 VAC (110v models) or 200-230VAC (220v models) 50/60 HZ electrical receptacle. Product label located on the heating or cooling unit clearly indicates power requirements. Use ONLY power cords supplied by Cambro Manufacturing. -
Page 5: Operating Instructions For Non-Electric Use
Open Probe Error Short Circuited Probe Error VI. Operating Instructions for Non-Electric Use For best operating results, the Pro Cart Ultra Passive holding carts should ideally be pre-heated or pre-chilled for at least ™ 20 to 30 minutes before loading with food. -
Page 6: Care & Maintenance
VII. Care and Maintenance A. MODULES WARNING! Completely cool heater unit prior to cleaning or maintenance. WARNING! Do not submerge heater or cold module in water or spray water on it. WARNING! Do not get the thermometer wet in any way. WARNING! Unplug grounded power source from module prior to cleaning. -
Page 7: Troubleshooting Guide
• Control thermostat is not working. NOTE: For service please contact Cambro at 800-854-7631 X4118. Please refer to the model number and serial number when you call in. Units under warranty should be serviced by Cambro Authorized Service Agent Only. -
Page 8: Replacement Parts
Claims contact your local Cambro Representative. 2. The Liability of Cambro Manufacturing is limited to the repair or replacement of any part found to be defective. Parts and labor required for preventative maintenance or cleaning are not covered under this warranty.