Advertisement
This quick installation guide was designed to help with the basic configuration for the Captor M. More
detailed information can be found in the installation guide.
Connector
J1
J2
J3
J4
J5
J6
J7
J8
J9
J10
J11
J12
J13
J14
J15
J16
J17
J18
Ethernet 1 (Optional 10/100/1000) RJ45
J19
J20
J21
J22
J23
J24
Ethernet 2 (Optional 10/100 or 10/100/1000) RJ45
J25
J26
Keyboard/Mouse Combined PS/2
J27
J28
J29
J30
J31
J32
Audio – Line Out/Microphone In Header
J33
External RTC/CMOS Battery – Close to Battery Holder
J34
Mini-PCI Slot – Back side of the board
S1
S2
U18
U21
Description
LVDS
LVDS Backlight
COM3
COM1
COM5
DDR DIMM Socket 1
Rear Chassis Fan
Alt. Secondary IDE – 44-pin
COM4
COM2
COM6
DDR DIMM Socket 0
Secondary IDE
Floppy Disk Drive Connector
Primary IDE
Front Panel Header
ITP
USB Header (Ports 0 & 1)
USB Header (Ports 4 & 5)
USB Header (Ports 2 & 3)
LPT - Parallel
ATX PS Control
JTAG
CPU Fan
Audio – CD In Header
Audio – Line In Header
VGA DB15
Buzzer – Alt. Speaker Header
PICMIG ISA Edge
PICMIG PCI Edge
BIOS Socket
CPU Socket
Advertisement
Table of Contents
Summary of Contents for Corvalent Captor M
- Page 1 This quick installation guide was designed to help with the basic configuration for the Captor M. More Connector Description detailed information can be found in the installation guide. LVDS LVDS Backlight COM3 COM1 COM5 DDR DIMM Socket 1 Rear Chassis Fan Alt.
- Page 2 System Memory Features: The Captor M allows an upgrade of the system memory with up to 2GB unbuffered SDRAM DDR DIMM modules in two memory slots. ECC and non-ECC DDR SDRAM modules are supported, PC1600 (DDR 200MHz), PC2100 (DDR 266MHz) and PC2700 (DDR 333MHz).
Need help?
Do you have a question about the Captor M and is the answer not in the manual?
Questions and answers