ClearSounds QH2 Quick Start Manual

1. SETTING UP THE QH2 HUB FOR CORDED TELEPHONES

STEP 1: Remove the STEP 2: Connect
curly cord from the the short
phone base and Hub-to-base cable
connect it to the to the phone base
HANDSET port on port where the curly
the bottom of the cord had been
hub. connected.

2. TO PAIR THE QH2 HUB WITH A BLUETOOTH HEADSET, STREAMER OR NECKLOOP

STEP 1: Wear your STEP 2: On the hub,
Bluetooth listening press and hold the
device and remain multi-function
within 33 feet of the button (MFB) until
QH2 hub. the blue and red
lights flash.
STEP 3: Connect STEP 4: Connect
the unattached end the round end of the
of the Hub-to-base AC power adapter
cable to the BASE to the DC 9V port on
port on the top side the left side of the
of the hub. The hub, then plug the
green light will other end of the AC
illuminate. adapter into a
power outlet in the
wall.
STEP 3: Turn on STEP 4: Confirm
your listening that you hear a dial
device, then place it tone in the handset
in Bluetooth pairing by manually lifting
mode. When hub the handset from
and listening device the base.
are paired, the hub
flashes a blue light
every three
seconds. Your
listening device also
indicates when
pairing is success-
ful.
For full manual visit www.clearsounds.com
STEP 5: Pick up the STEP 6: If you do
not hear a notice-
telephone handset.
If you hear a dial able dial tone: On
tone: On the hub, back of QH2, click
slide the VOLUME the dial until you
slider or TONE hear a dial tone. On
slider until you hear the hub, slide the
a noticeable change VOLUME slider or
in volume and tone TONE slider until
quality. you hear a change
in volume and tone
quality. Repeat
these steps until
you find a compati-
ble setting.
STEP 5: On the hub, STEP 6: Press and
press and release release the MFB.
the MFB to hear the The dial tone stops.
dial tone in your Manually return the
Bluetooth headset, handset to the base.
neckloop or
streamer.

QUICK START GUIDE