Table of Contents
Advertisement
In case you need to connect the device to PC or notebook directly,
you should use a cross-over cable instead.
Note
5.3 Hardware Installation
1. Fix ICA-350 to the location with wall mount fixture.
2. Plug-in Ethernet Cable into RJ-45 LAN port. Connect an Ethernet cable to the
LAN port on the ICA-350 and connect the other side of the Ethernet cable to a
hub/switch.
3. Connect the attached two power adapters to camera and plug-in this two
adapters into power outlet.
4. Connect Video BNC connector to a local TV monitor or DVR if necessary.
5. Done.
RJ-45 LAN Connector
For connect a LAN cable to your Hub/Switch.
The LAN port is a RJ-45 connector for connections to
10Base-T Ethernet or 100Base-TX Fast Ethernet cabling. This
Ethernet port built N-Way protocol can detect or negotiate
the transmission speed of the network automatically. Please
use Category 5 "straight" cable to connect the ICA-350 to a
100Mbps Fast Ethernet network switch or hub.
Power Connector (for heater)
Connect to DC 12V power adapter.
Line in (audio in) *hardware version 2
Connect an audio input source to the ICA-350.
Line out (audio out) *hardware version 2
Connect a loud speaker to the ICA-350. This function is for
voice alerting and two-way audio.
13
Advertisement
Table of Contents
