Federal Communications Commission Notice - Cambridge Audio Edge NQ Instructions Manual

FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.

FEDERAL COMMUNICATIONS COMMISSION NOTICE

This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses, and can radiate radio frequency energy, and if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception,
equipment off and on, the user is encouraged to
which can be determined by turning the
try and correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate this
equipment.
2.4 GHz Wi-Fi operation of this product in the USA is hardware limited to channels
1 through 11.
RF EXPOSURE STATEMENT:
To maintain compliance with FCC's RF Exposure guidelines, This equipment
should be installed and operated with minimum distance between 20cm the
radiator your body: Use only the supplied antenna.
MODIFICATIONS
The FCC requires the user to be notified that any changes or modifications to this
device that are not expressly approved by Cambridge Audio, may void the user's
authority to operate the equipment.
CANADA-INDUSTRY CANADA (IC)
This radio transmitter has been approved by Industry Canada.
This device complies with Industry Canada License exempt RSS standard(s).
Operation is subject to the following two conditions.
(1) this device may not cause interference and (2) this device must accept any
interference, including interference that may cause undesired operation of the
device.
This equipment should be installed and operated with a minimum distance of
20cm between the radiator and your body.
The transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
INDUSTRIE CANADA (IC)
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil
doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
Cet équipement doit être installé et utilisé à une distance minimale de 20 cm entre
le radiateur et votre corps.
L'émetteur ne doit pas être co-placé ni fonctionner en conjonction avec une autre
antenne ou transmetteur.
EUROPE-EUROPEAN UNION NOTICE
Radio products with the CE marking comply with the RED Directive (2014/53/EU)
issued by the Commission of the European Community.
Compliance with this directive implies conformity to the following European
Norms.
• EN 60065 – Product Safety.
• EN 300 328 – Technical requirement for radio equipment.
• EN 301 489 – General EMC requirements for radio equipment.
4