Tyger FENDER FLARE TG-FF8D4078 Installation Instructions

Before Installation

Verify the tment of the ares to vehicle prior
installation. (Some ling, sanding or cutting
may be require to ensure proper t)

If Painting is needed

If paint is desired, it must be done prior to
installing ares on vehicle. DO NOT USE
LACQUER THINNER OR ENAMEL REDUCER AS A
DEGREASER. Wipe outer surface thoroughly
with a tack rag prior painting. Paint ares by
using a high quality enamel, or polyurethane
automotive paint. If painting edge trim (not
recommend), use a ex additive

Clean thoroughly before application

Wash and wipe dry the surface and inside
edge of the fender are where the rubber seal
is to be attached.

Apply Rubber Seal

Remove a 1 inch tape liner from rubber seal
and apply it to the out edage of the are, start
from one end go along the edge that comes in
contact with body panel, apply pressure on the
tape to ensure that it adheres well, trim if any
excess.
5/16 x 18 x3/8" .320 x .700 x .03
Allen Bolt SS Washer
x40 x40
Self
Push-in Clip tappling screw
x10 x10
1/2
TM
TG-FF8D4078
5/16-18 Jam Fin.
Tu ok
Allen Nut
x40 x10
Rubber Seal
350 inches
x1
T-45 Allen Key
x1