Page 1
2008 Ducati Desmosedici Z-Fi TC Installation Instructions P/N T143 WARNING! USE ONLY IN RACE OR OTHER CLOSED COURSE APPLICATIONS AND NEVER ON PUBLIC ROADS Z-Fi products do not meet California CARB highway requirements Parts List: Z-Fi TC/QS Control Unit Mounting Bracket...
Page 3
2. Install the supplied control unit mounting bracket to the right side engine cover securing it in place us- ing the two top cover bolts. Insert the Bazzaz control unit into the bracket. Connect the Bazzaz harness to the control unit and route the remainder between the frame and front cylinder into the engine compart- ment (photos 1 &...
Page 4
Photo 4 Photo 5 4. Route the portion of the Bazzaz harness containing the power and neutral connectors toward the rear of the motorcycle along the right side. Locate the factory harness rear brake light switch power supply connector which can be found near the engine oil filler cap. Disconnect the factory harness connectors and install the Bazzaz harness power supply connectors in line (photos 6 &...
Page 5
5. Continue to route the neutral sensor lead of the Bazzaz harness (white/blue wire with T-tap) to the rear of the engine. Locate the factory harness neutral sensor wire (yellow/green) and crimp on a supplied scotch lok connector onto this wire. Insert the Bazzaz neutral sensor T-tap connector into the scotch lok and reinstall the factory harness connector onto the sensor at the rear of engine (photos 8 &...
Page 6
P1 page19. 9. Route the shift switch lead of the Bazzaz coil harness to a location on the left side of the motorcycle which will allow for accessing the connector when connecting the mating shift switch lead once the air box and fuel tank are reinstalled (photo 13).
Page 7
12. Reinstall the components removed in step one of these instructions. The Bazzaz controller is capable of storing two maps. These maps can be selected through the use of a map select switch which can be mounted on the handlebar for easy access and can be purchased seper- ately.