The operator and maintenance personnel must physically be able to handle the bulk weight and power of this machine. The SATELLITE 760-6 Generation3 must only be used according to the instructions given in this manual. Any other work methods or practices could result in injury or death The SATELLITE 760-6 Generation3 has different positions in which the handle can be locked into.
The SATELLITE 760-6 can produce sound pressure levels greater than 85db. The operator must wear approved safety ear protection. Do not allow the supply cord to come in contact with the cutting blade/head or other moving parts of this machine. 1800 356 673 Floorex Products...
Wear clothes suitable for the job and for the work place including, safety shoes, hard hat, hearing protection, non-fogging vented safety goggles, and dust respirator suitable for dust. The SATELLITE 760-6 Generation3 must only be used according to the instructions given in this manual. Any other work methods or practices could result in injury or death WARNING! Disconnect power before moving the Handle to the ‘TOOLING POSITION’...
SATELLITE 760 Generation3 Operating Instructions The SATELLITE 760-6 Generation3 has axle height adjustment to make it easy to adjust the machine so it doesn’t cause fatigue on the operator. To set axle height, adjust the axle height leaver to the vertical position, or midpoint.
SATELLITE 760-6 Generation3 Page 7 / 24 Handle Positions The handle on this machine can be locked in different positions for different purposes. These positions must only be used for the purpose intended as outlined in this manual. . Failure to comply could result in bodily injury.
Ensure the insert is not worn to less than 20mm diameter where the blade runs on the insert. This is equivalent to the diameter of the section above it. Put the insert through the satellite disk and install the two parts onto the plug ensuring the insert goes completely into the plug. 1800 356 673 Floorex Products...
SATELLITE 760-6 Generation3 Page 9 / 24 Axle height adjustment This machine is designed to operate with the wheels in contact with the floor at all times. Do not operate with wheels off the floor. The axle lever must be set as far back (toward operator) as possible without creating excess force on the operator during operation.
Hours run is only counted when machine is being used (over 0.5 Amps) and counted with accuracy of two decimal places The first decimal place is a 10 of an hour being 6 minutes The second decimal place is a 10 of 6 minutes being 36 seconds. 1800 356 673 Floorex Products...
WARNING - DO NOT operate the machine with any electrical panels open. WARNING - The controls on the SATELLITE 760-6 Generation3 include an over load device. It is there to protect the controls and motor from irreparable damage. If it trips it indicates a problem. (i.e.; undersize power lead or poor power to your power supply).
This reduces the weight on the The diamonds are too diamonds thus reducing the wear Use weights on the handle soft or too few. on them. NOTE: THIS IS A GUIDE ONLY 1800 356 673 Floorex Products...
10mm Segment This list is only showing the Satellite 7” Disks, Many other types of tooling is available for polishing, Removal, cleaning, and even sanding timber. Contact your representative for more information or go to www.floorex.com.au 1800 356 673 Floorex Products...
SATELLITE 760-6 Generation3 Page 21 / 24 Warranty This Warranty covers the Satellite Generation3 Machines for periods noted in the table below. Machine/Item Period Notes and additional Options All Satellite Generation 3 machines 2 years Cycloid Transmissions 2 years An extra 3 years is offered, extending warranty to 5...