Do you have a question about the DG9T-15K619-CF and is the answer not in the manual?
Questions and answers
Summary of Contents for Delphi DG9T-15K619-CF
Page 1
Document Title: BI-NEU RTM Homologation Description Page 1 / 5 BI-NEU Radio Transceiver Module (RTM) Homologation Document Part Number: DG9T-15K619-CF Table of Content Preface ______________________________________________________________________________ 2 Configuration and Identification of Equipment Under Test (EUT)______________________________ 3 Description ______________________________________________________________________ 3 Identification-Labeling _____________________________________________________________ 3 Operation Declarations ____________________________________________________________ 3 2.3.1...
Page 2
Document Title: BI-NEU RTM Homologation Description Page 2 / 5 Preface This document provides an overview of the North American Bi-Directional Radio Transceiver Module for Homologation Testing „NOTICE: This device complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt RSS standard. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired...
Page 3
Document Title: BI-NEU RTM Homologation Description Page 3 / 5 Configuration and Identification of Equipment Under Test (EUT) Description The EUT contains circuitry and software in order to receive Long range RF data from vehicle equipped Remote Keyless Entry Transmitters and short range RF data from Tire Pressure Wheel Sensors. The EUT demodulates and determines whether the demodulated data should be sent to vehicle Body Control Module via a dedicated vehicle serial bus.
Page 4
Document Title: BI-NEU RTM Homologation Description Page 4 / 5 Equipment Type RF Receiver Country of Origin: Mexico 7.0VDC to 24VDC -40 deg C to + 105deg C Operating Voltage Operating Temperature 8.0 VDC to 16VDC (Nominal) 902.425 MHz +/- 210kHz FSK w/ + 7.5kHz Operating Freq Range Modulation...
Page 5
Document Title: BI-NEU RTM Homologation Description Page 5 / 5 2.3.2 Variants The EUT only supports one configuration setting $DE00 = 0x1 EUT Samples & Configuration One unmodified sample, one receive test sample for low band reception (315MHz), one receive test sample for high band reception (903MHz) and eight transmit test samples were provided to the homologation vendor for certification testing and approval in the countries defined in the statement of work.
Need help?
Do you have a question about the DG9T-15K619-CF and is the answer not in the manual?
Questions and answers