Page 2
Lubricate the inside and the out- Insert the halves into the sleeve. from the halves until you reach the right outer diameter according to the side sealing surfaces with Roxtec table on the previous page. The number of outer layers may not differ by Lubricant.
Page 3
Continue the reinstallation from step 6. Note ■ Wait 24 hours or longer after installation before exposing the cables/pipes to strain or pressure. ■ Cables shall go straight through the frame. ■ Amendments to these installation instructions are available on www.roxtec.com.
Page 4
Roxtec part of the Roxtec system. Thus, the certification is not valid and does not apply systems or installations containing components not manufactured by an authorized...
This manual is also suitable for:
Rs 125 omdRs 68 omdRs 50 omdRs 100 omdRs 25 omdRs 43 omd...
Show all
Need help?
Do you have a question about the RS 150 OMD and is the answer not in the manual?
Questions and answers