Summary of Contents for Flowserve SLD
- Page 1 Installation Instructions Synthetic Lubrication Device Seal Support System Experience In Motion...
- Page 2 The SLD allows for hand rotation of shafts as requested by many bearing manufacturers to reduce scoring effects to mechanical seal faces during the procedure.
- Page 3 INLET quench connection of the seal. The maximum length of pipe from SLD auto- luber to INLET quench connection of the seal should be 460 mm (18 inches).
- Page 4 SLD to the seal. It should be filled with clean grease prior to start up and vented to make sure no air has been trapped prior to start up.
-
Page 5: Normal Operation
The longer the dispensing period selected the longer the delay before lubricant is dispensed. See Figure 3. If immediate dispensing is desired, prestart the SLD auto- luber unit 12 hours prior to installation by moving all DIP switches to the “On”... - Page 6 The rate of dispensing will increase at higher altitudes and decrease at lower altitudes because of the difference in atmospheric pressure acting against the SLD auto-luber unit. For every change in elevation of 305 meters (1000 feet) from sea level, the discharge rate will naturally increase or decrease by an additional 5%.
-
Page 7: Maintenance
SLD auto-luber and the unit needs to be replaced. Note: An empty SLD auto-luber might still have a flashing red light. There is no light pattern that indicates that the SLD auto-luber is empty. Level must be checked by... -
Page 8: Specifications
Telefax: 31 765 028 487 selected, this Flowserve product is designed to perform its intended function safely during its useful life. However, the purchaser or user of Flowserve products should be aware that Flowserve products might be used in numerous applications under a wide variety of industrial service conditions.