Page 2
4. Hold one half element on the hubs to determine Lock out / tag out the power the appropriate hub spacing. If using spacer source before proceeding to avoid unexpected elements with high speed rings, hold both half starts. Failure to observe these precautions could elements on hubs to make sure that the hubs result in bodily injury.
Page 3
8. Tighten motor and driven equipment fasteners 10. Install coupling guard per applicable safety to manufacturer specifications; recheck parallel regulations. and angular alignment. 11. Periodically check alignment, as settling will 9. When parallel and angular alignment values are often change equipment position. within service ratings, verify that all set screws, cap screws and other fasteners are tightened to values in Table 1.
Need help?
Do you have a question about the Dura-Flex Coupling and is the answer not in the manual?
Questions and answers