NETGEAR AXM765 Installation Manual

Installation Guide
10GBASE-T/1000BASE-T SFP+ Module
Model AXM765
The AXM765 SFP+ module is a low-power, high-performance, multi-gigabit
10G/1000BASE-T transceiver. The AXM765 delivers 10 Gb network connectivity
with cabling up to 98.5 feet (30 meters) and delivers 1G network connectivity
speed through 328 feet (100 meters) of Category 5e (Cat 5e) or Cat 6 Ethernet
cable.
The module is compatible with the IEEE 802.3an/ab standard.
The switch automatically detects the module, so you can simply plug it into an
available module slot. You can insert or remove the module while the switch is
operational.
Install the Module
Insert the module firmly into a slot that supports the SFP+ interface. Make
sure that the cable you use is Category 5e (Cat 5e) or higher rated Ethernet
cable (Cat 6, Cat 6a, or Cat 7).
Remove the Module
1. To release the module latch, pull up the handle bar across the module.
2. Pull the module out of the module slot.
Technical Specifications
Standards IEEE 802.3an, IEEE 802.3ab, SFF-8431 and SFF-8432
MSA-compliant
Dimensions (H x W x D) 0.53 in. x 0.53 in. x 2.57 in.
(13.7 mm x 13.4 mm x 65.4 mm)
Weight 0.5 oz (14.17 g)
Operating temperature 32–158ºF (0–70ºC)
Operative relative 85% at 77ºF (25ºC)
humidity
Operating distance 10GBASE-T up to 98.5 ft (30 m) with Cat 6a (or higher
rated) Ethernet cable
1GBASE-T up to 328 ft (100 m) of Cat 5e (or higher
rated) Ethernet cable
Connectors RJ45
Power consumption 2.5W
Safety certification IEC/EN 60950-1, UL60950
Environmental compliance RoHS