Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Labgear HDX60P
Summary of Contents for Labgear HDX60P
-
Page 1: User Guide
HDX60P HDMI 60m Extender Kit with POE over single CAT 5e/6/7 User Guide ®... - Page 2 General Safety • To prevent re or shock hazard, do not expose any part of this device to rain or moisture. • This product is for indoor use only • Do not expose the product to extreme heat • Do not disassemble any of the units in this kit they contain no user serviceable parts.
-
Page 3: Speci Cations
Speci cations Video Bandwidth: Single-link 165MHz (4.95Gbps) Video Support: 480i/480p/720p/1080i/1080p @ 60Hz Audio Support: Surround Sound (up to 7.1 ch) or stereo digital audio Transmission Range: HD (1080p 24bit color) - up to 60m Input TMDS Signal: 3.3V Input DDC Signal: 5.0 V/P-P ESD Protection: +/- 8 kV (air-gap discharge) - Page 4 Transmitter - Sockets and Switches ① HDMI IN: Via an HDMI cable connects to the HDMI output port of your source equipment such as DVD/Blu-ray players or set top box. ② EDID SWITCH: Switched to the right, the extender will copy the EDID information for the display connected to the HDMI loop out to the source equipment.
- Page 5 Receiver - Sockets and Switches ① EQ SWITCH: HDMI Receiver equaliser switch. ② HDMI OUT: Via an HDMI cable connects to the HDMI input of a display such as an HDTV. ③ IR IN: Connection for the IR Receiver cable included in the pack for IR signal reception.
-
Page 6: Connection And Operation
Connection and Operation HDMI Cable Network Cable HDMI Cable HDMI Cable IR Receiver 1. Connect a source such as a Blu-Ray Player, game console, A/V Receiver, Cable or Satellite Receiver, etc. to the HDMI input on the Transmitter. 2. Connect a display such as an HDTV or HD Projector to the HDMI output on the Receiver. - Page 7 Wideband IR Blaster and Receiver The HDX60P kit is supplied with a wideband IR Blaster and Receiver they respectively emit or recieve IR signals in the 30-60kHz range. IR Blaster (TX) To control the source: Plug the IR Blaster into the IR OUT socket on the transmitter, place the Blaster as close as possible in front of the IR sensor of the source device.
-
Page 8: Technical Support
Customer Careline: 08457 573 479 Local rate: UK Only www.labgear.co.uk Waste electrical and electronic products must not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority for recycling advice. © Labgear 2015. v1 MK42 0NX...
Need help?
Do you have a question about the HDX60P and is the answer not in the manual?
Questions and answers
WHY IS dc 5v SO LOOSE