Advertisement
8
Remove red wire (A) from input PC board as shown in
above drawing.
10
Unplug connector attached to the end of the red wire
(A) and black wire (B) from the PC board and set aside.
This cable connection is no longer needed for use with
the transformer.
9
9
Place wire from transformer primary (F, G, H, or I) that
corresponds to the desired wattage needed to tap (see
chart of values on page 1) to the now open former
location of the red wire (A). **Please note above example
shows red wire (F) connected to input PC board which is
the 300W tap for 70V use.
11
Attach yellow wire (D) and green wire (C) to the now
open former location of the connector from the red
wire (A) and black wire (B). This is the location for the
positive "+" and negative "- " wires from the
transformer secondary.
Advertisement
