JEDI™
TRAINING REMOTE
INSTRUCTION MANUAL
Gameplay
The Jedi Training Remote (JTR) has 2 modes:
• Mode 1 - RC. Squeeze the trigger of the handset to
control the Jedi Training Remote's height and speed.
Press the button at the rear of the handset to activate
sting beams.
• Mode 2 - Force Control. Patented Proximity Sensors.
Press the FORCE CONTROL button on the handset
to activate Auto-Hover and Object detection system.
Sensors in the Jedi Training Remote will now detect
any solid objects below, including hands and feet,
and will fly up and away while firing simulated
sting beams!
Press the FORCE CONTROL Button again to stop.
Please Note: If the JTR Heliball crashes it automatically turns itself off. To resume flying turn the Heliball back on.
Important
Indoor use only.
Before use, please ensure an adult has installed the batteries, into the remote control, correctly using the
instructions shown in this instruction manual. Please retain this information for future reference.
Battery Installation
Uses: 3 x 1.5V AAA alkaline batteries
(not included)
Use a small screwdriver (not included) to remove
the battery compartment cover. Install the batteries,
making sure the polarity (+ and -) is matched with
the symbols on the remote control handset. Replace
battery compartment lid and secure.
Charging - (Charge before use.)
The Jedi Training Remote charges via the USB cable.
The internal LED light will turn on to indicate charging
and will turn off when fully charged. Make sure the
Jedi Training Remote is off while charging.
Note: Charge time of 30 minutes will provide flying time
of approximately 5 minutes.
Jedi Training Remote ON/OFF function
Press the ON/OFF button.
2 orange lights will flash and the JTR is now on standby
ready for flying.
Remote Controller ON/OFF function
Install 3x AAA battery
Press the FIRE button, a red light will flash slowly.
Pull the trigger back and release. The red light will now
stay lit, signifying the handset is now paired and ready
to fly the Jedi Training remote.
To turn off the JTR
Press the ON/OFF button again to switch off.
To turn off the controller
Press the FIRE button for 3 seconds.
Sleep mode function
Hold the FIRE button on the remote controller for 3
seconds to enter sleep mode. The JTR will also enter
sleep mode if there is no action from the remote
controller or the JTR after 10 minutes.
MODE 2
Patented proximity
Use hands or feet!
FORCE
CONTROL
button
FIRE
button
Sensor
ON/OFF
Control Jedi Training
Remote remotely!
MODE 1
sensors.
3 x 1.5V
"AAA"(LR03)
Trigger
USB
Charging
Switch
CHA
ON / OFF
Need help?
Do you have a question about the JEDI and is the answer not in the manual?
Questions and answers