Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Omni UVS-4**D1 Series
- Page 1 DVR Installation Manual 5/13/2013 V1.0 UVS-4xxD1 DVRs...
-
Page 2: Table Of Contents
Encoding Settings .................................... 10 Motion Recording Setup (optional) ..............................11 ALARM INPUT SETUP ..............................12 CONFIGURE I-VIEW NOW ENTRY DELAYS ......................13 TEST SETTINGS ................................13 © 2013 I-View Now, LLC. All Rights Reserved. Omni UVS-4xxD1 Installation Guide rev 1.0 Page 2... -
Page 3: Workflow
I-ViewNow portal. 9. Trouble Shooting: This section is provided to help the technician troubleshoot common problems encountered while installing S series DVR’s. © 2013 I-View Now, LLC. All Rights Reserved. Omni UVS-4xxD1 Installation Guide rev 1.0 Page 3... -
Page 4: Installation Worksheet
DVR unit. The default password is admin. Be aware that the Menu’s presented in this manual can vary slightly depending on the exact model and firmware version. User Name: admin Password: admin VGA Cable USB Mouse VGA Port © 2013 I-View Now, LLC. All Rights Reserved. Omni UVS-4xxD1 Installation Guide rev 1.0 Page 4... -
Page 5: Network Setup
From the Settings Menu click Network This is the Main Menu Continued Next Page… This is the Settings Menu from which most device programming will be initiated © 2013 I-View Now, LLC. All Rights Reserved. Omni UVS-4xxD1 Installation Guide rev 1.0 Page 5... - Page 6 Click save to ensure no settings are lost before proceeding This is the general network settings interface. All network settings programming is initiated from this interface. © 2013 I-View Now, LLC. All Rights Reserved. Omni UVS-4xxD1 Installation Guide rev 1.0 Page 6...
-
Page 7: Smtp Settings
Test will not verify that the Sender and Receiver are correct. It just verifies connectivity to the I-View Now SMTP Server. Email Setup Interface. Reachable through Network Settings interface © 2013 I-View Now, LLC. All Rights Reserved. Omni UVS-4xxD1 Installation Guide rev 1.0 Page 7... -
Page 8: Network Port Setup
For any of these situations it is the External IP Address and External Port numbers that must be entered into the I-View Now “Installer’s Portal.” Note: Any ports used must be unblocked in any firewall devices (typically just the router). © 2013 I-View Now, LLC. All Rights Reserved. Omni UVS-4xxD1 Installation Guide rev 1.0 Page 8... -
Page 9: User Settings
Click on the ‘admin’ user(login local) Change the password to the password provided by the dealer’s web portal Confirm change Click OK Click Save © 2013 I-View Now, LLC. All Rights Reserved. Omni UVS-4xxD1 Installation Guide rev 1.0 Page 9... -
Page 10: Recording Setup
Recording Setup The Omni DVR records video VIA 2 different stream types. I-ViewNow utilizes Extra Stream1 to stream live video from the DVR. I-ViewNow can uses the main recording stream to retrieve Pre-Event Video Clips. Encoding Settings The Encoding setup determines format of the video record onto the DVR. For clips to be decoded properly the frame rate must be set to 15 FPS on the recording channel being utilized. -
Page 11: Motion Recording Setup (Optional)
Can be utilized to exclude areas from Motion detection Set record channel to record the channel Motion was triggered on. IE Channel 2 Should record channel 2 © 2013 I-View Now, LLC. All Rights Reserved. Omni UVS-4xxD1 Installation Guide rev 1.0 Page 11... -
Page 12: Alarm Input Setup
Check record channel Check all Channels Optionally check buzzer Checking buzzer makes the DVR Beep when an alarm input is fired © 2013 I-View Now, LLC. All Rights Reserved. Omni UVS-4xxD1 Installation Guide rev 1.0 Page 12... -
Page 13: Configure I-View Now Entry Delays
DVR has received the signal. Also ensure that the I-ViewNow.com portal has received the signal and correctly identifies the type of alarm. © 2013 I-View Now, LLC. All Rights Reserved. Omni UVS-4xxD1 Installation Guide rev 1.0 Page 13...
Need help?
Do you have a question about the UVS-4**D1 Series and is the answer not in the manual?
Questions and answers