Summary of Contents for Del ozone MPI-300
- Page 1 MPI-300 Multi-Point Intervention Ozone Sanitation System Installation & Operations Manual 3580 Sueldo Street, San Luis Obispo, CA 93401 | 800.676.1335 | o3info@delozone.com | www.delozone.com 4-0700 Rev.E...
- Page 2 MPI-300 Installation & Operations Manual IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS. Read this manual completely before operation of AGW–0500 Ozone Generator Equipment. The High Voltage Transformers in this unit create 7,000 volts, with the outer jacket of the High Voltage lead reaching 3,000 volts.
-
Page 3: Table Of Contents
1A. MPI-300 Description ..........1 5A. Ordering Information ..........4 1B. MPI-300 Specifications ..........1 5B. Standard Replacement Parts List ......4 1C. MPI-300 Layout & Accessories ....... 1 SECTION 6 General Ozone Use and Safety SECTION 2 Installation Procedures 6A. -
Page 4: Section 1 General Information
100 lbs. configurations, MPI-300, MPI-300WM, and MPI- Ambient Temp: 40°F - 90°F (not to 300M. The MPI-300 is the base model system exceed 90°F) designed for general, in place surface sanitation applications including equipment sanitation of 1C. Layout & Accessories conveyors, slicers, saws, etc. -
Page 5: Mpi-300 Layout & Accessories
2C. Plumbing MPI-300 Components MPI-300 1. Air Compressor The standard MPI-300 is supplied with 3/4” FPT 2. Oxygen Concentrator bulkhead fittings for water inlet and outlet. It is 3. Ozone Generation Cell designed to be plumbed on site per the user’s 4. -
Page 6: Section 3 Operation
6. Disconnect the garden hose from the fitting. (Some water will drain out.) 3D. Standard Operating Procedures NOTE: The MPI-300 provides a final sanitizing rinse, leaving no residual. 3D-1. Surface Sanitation The spray can be directed on all wettable wood,... -
Page 7: Section 4 Maintenance & Service
Procedure EVERY 18,000 HOURS: 1. Familiarize self with HACH AccuVac test kit. 2. Start-up MPI-300, place and hold spray wand in 1. Replace ozone generation cell. (DEL P/N 9-0925) 5 gallon pail, and allow to flow for three to four minutes (NOTE: ensure the tip of the spray 4B. -
Page 8: Section 5 Replacement Parts
MPI-300 Installation & Operations Manual SECTION 5 REPLACEMENT PARTS 6A-2. Materials Selection AND ORDER INFORMATION Aqueous Ozone Materials 0-3 ppm Freshwater 5A. Ordering information: Metals: Copper For replacement parts call DEL at 1-800-676-1335 Brass or for international call 805-541-1601. 316L Stainless Steel... -
Page 9: Hazards
(regardless of how small) is theoretically without effect from ozone’s strong oxidative ability. Slight off-gassing of ozone can occur from the spray water that is produced by the MPI-300 (the physical properties of ozone make this unavoidable). Laboratory and field testing in varying environments... -
Page 10: Precautions For Safe Handling And Use
The education and training of workers is the cart with safe access to electrical power. Connect responsibility of the employer. An effective the MPI-300 to a GFCI type receptacle. Do not training program must be practical, based on bury the electrical cord. To reduce risk of electrical written work procedures and be specific to both shock, replace damaged cord immediately. - Page 11 MPI-300 Installation & Operations Manual 6E-2. Monitoring Equipment monitoring for exposure times ranging from OZONE IN AIR 5 minutes to 10 hours. For higher resolution, Electronic Ambient Ozone Monitor the ChromAir ozone badge may be used in a. Shall measure the level of ozone present...
-
Page 12: First Aid Procedures
MPI-300 Installation & Operations Manual 6F. First Aid Procedures 6F-5. EMERGENCY INFORMATION FORM An emergency information form (see page 10) 6F-1. GENERAL should be filled out prior to operation of ozone First Action: generator. 1. DO NOT PANIC. 2. If exposure to gaseous ozone causes 6G. - Page 13 MPI-300 Installation & Operations Manual APPENDIX “A” DAILY DATA LOG...
- Page 14 MPI-300 Installation & Operations Manual APPENDIX A...
- Page 15 MPI-300 Installation & Operations Manual APPENDIX “B” EMERGENCY INFORMATION...
- Page 16 MPI-300 Installation & Operations Manual...
- Page 17 MPI-300 Installation & Operations Manual APPENDIX “C” SAFETY...
- Page 18 MPI-300 Installation & Operations Manual Page 1 of 3 Material Safety Data Sheet NFPA 704 Designation Hazard Rating This MSDS complies with OSHA’s Hazardous Communication Standard 29 CFR 1910.1200 and OSHA form 174. 4 = Extreme DEL Ozone 3 = High...
- Page 19 MPI-300 Installation & Operations Manual Page 2 of 3 Material Safety Data Sheet Cont. Product Name AQUEOUS OZONE SOLUTION IV HEALTH HAZARD DATA Threshold Limit Value NOT DETERMINED Route of Exposure Inhalation Ingestion Skin Not Hazardous Eye Contact Hazard Exposure may cause mild eye irritation, but is not expected.
- Page 20 Other Protective NOT REQUIRED Equipment IX SPECIAL PRECAUTIONS Certified testing of DEL Ozone systems by NSF (National Sanitation Foundation) has shown that Precautionary under normal conditions of use, aqueous solutions containing low levels of ozone gas dissolved in Labeling potable water do not present a safety hazard when contact to the individual is incidental. When...
-
Page 21: Warranty
DEL OZONE TWO YEAR LIMITED WARRANTY The limited warranty set forth below applies to products manufactured by DEL OZONE – 3428 Bull- ock Lane, San Luis Obispo, California 93401, and sold by DEL OZONE and its authorized dealers. This limited warranty is given only to the first retail purchaser of such products and is not transfer- able to any subsequent owners or purchasers of such products. - Page 22 3580 Sueldo Street, San Luis Obispo, CA 93401 | 800.676.1335 | o3info@delozone.com | www.delozone.com EPA Estab. No. 071472-CA-001...