Advertisement
118 S. Main St ***Suite 9 -Wauconda, IL 60084 -
847-224-7914
PM42 Breakout Board Installation Instructions
The breakout board eliminates soldering connections to the card edge or card edge
adapter of a PM42 circuit breaker/reverser board.
Making Connections:
Strip approximately .125" (1/8 inch) off your wire. Either solid or stranded wire can
be used, from 12 AWG to 26 AWG. Insert the bare portion of the wire into the terminal
block and tighten the screw to make a solid connection.
Do not over-tighten
,
as the terminal blocks can be stripped or broken with too
much force.
The instructions on the next page describe the board and connections as if the large
connector for the PM42 is at the top; matching the orientation of the picture above.
Advertisement
Table of Contents
Need help?
Do you have a question about the PM42 and is the answer not in the manual?
Questions and answers