Titus TMR Installation Manual

Insert the inner cone assembly
Step One
upwards into the outer cone
assembly aligning the inner cone
assembly tangs with the receptor
slots on the outer cone assembly.
Step Two Rotate the inner cone assembly 10o
so that the retainer point has passed
the receptor slot and the weight of
the inner cone assembly is supported
by the receptor slots of the outer
cone assembly. A set of springs clips
apply pressure to the tangs locking
the tangs into the receptor slots.
7\SH   )L[HG 3RVLWLRQV
3RVLWLRQV



7\SH  6OLGLQJ
6OLGH LQQHU FRUH
XS DQG GRZQ
7\SH  5RWDWLQJ
5RWDWH FHQWHU FRQH

Securing the Inner Cones

Adjusting Inner Cone Position (TMRA only)

Type 1 Inner Cone:
The type 1 inner cone assembly has three fixed cone positions. The cone
position is adjusted by removing the cone assembly and repositioning it.
To reposition the inner cone assembly remove the positioning screws and
align the screw hole with the new position desired. Insert and tighten the
screws in the new position.
Type 2 Inner Cone:
(Steel only, sizes 6"-12")
The type 2 inner cone assembly is adjusted by sliding the inner cones up or
down as desired.
To reposition the cones loosen the positioning screws and slide the cones to
the new position. Tighten the screws to secure cones in place.
Type 3 Inner Cone :
(Steel only)
The type 3 inner cone assembly is adjusted by rotating the center cone.
To reposition the cones, rotate the center cone clockwise or
counterclockwise to raise or lower the cones.
Page 1 of 2 (D-TMR-IM)
TMR Model
Step Three "L" shaped retainer brackets are
shipped retracted and must be
adjusted upwards against the outer
cone. After installation of the inner
cones, as described above, each "L"
slide retainer should be released and
extended upward against the outer
cone.
Step Four Lock each "L" slide retainer in place
with the screw provided to prevent
release of the tangs on the inner
cones from the receptor slots.
Note: Steps 3. and 4. below apply only to diffusers with neck
size of 14" through 36".