Advertisement
Quick Links
- THE PRODUCT MUST BE INSTALLED BY A QUALIFIED ELECTRICIAN.
- THE POWER SUPPLY MUST BE TURNED OFF BEFORE INSTALLATION.
- NO WARRANTY WILL BE ACCEPTED IF THIS PRODUCT IS NOT INSTALLED BY A QUALIFIED
ELECTRICIAN.
- THE LIGHT SOURCE CONTAINED IN THIS LUMINAIRE SHALL ONLY BE REPLACED BY THE
MANUFACTURER OR HIS SERVICE AGENT OR A SIMILAR QUALIFIED PERSON
- THE EXTERNAL FLEXIBLE CABLE OR CORD OF THIS LUMINAIRE CANNOT BE REPLACED; IF THE CORD IS
DAMAGED, THE LUMINAIRE SHALL BE DESTROYED.
- DO NOT OPERATE THE PRODUCT WITH A DAMAGED LENS; THE DAMAGED LENS SHOULD BE REPLACED BY
THE SERVICE AGENT.
- THE DRIVER CAN'T BE REPLACED.
- THE TERMINAL IS RATED VOLTAGE IS 300V,RATED CURRENT IS 3A,THE WRING IS NOT LESS THAN 3 X 1.0MM².
- WHEN PRODUCTS ARE INSTALLED IN HIGH WIND ENVIRONMENTS, APPROPRIATE INSTALLATION/FASTENING
METHODS MUST BE APPLIED SO THAT THE PRODUCT MOUNTING POINTS ARE NOT DAMAGED DUE TO
VIBRATION,MOVEMENT OR CORROSION.
- GOOD PRACTICE DOES NOT RECOMMEND CONTINUOUS USE WITHOUT APPROPRIATE SWITCHING CYCLES.
RÉF.
COB-BEL-135-VG
Installation of LED High Bay
1. Disconnect mains supply before installation or
removing cover.
LED High Bay Installation Guide
Size
300x270mm
135W
IP65
AC220-240V
2. Use a screwdriver to fix the reflector to the luminaire with screws.
50Hz
50
Advertisement
Summary of Contents for Ceotis COB-BEL-135-VG
- Page 1 METHODS MUST BE APPLIED SO THAT THE PRODUCT MOUNTING POINTS ARE NOT DAMAGED DUE TO VIBRATION,MOVEMENT OR CORROSION. - GOOD PRACTICE DOES NOT RECOMMEND CONTINUOUS USE WITHOUT APPROPRIATE SWITCHING CYCLES. IP65 RÉF. Size COB-BEL-135-VG 300x270mm 135W AC220-240V 50Hz Installation of LED High Bay 1.
- Page 2 3. Hook the end of the safety chain into the ring on the top of the All cable teminations must be installed in accordance with the luminaire. designed IP rating. 5. Reconnect mains supply CEOTIS ECLAIRAGE C/O SOITEC Parc technologique des fontaines Chemin des Franques 38190 Bernin France Email:contact@ceotis.fr...