Electrical Connection - Diamond Products CB733 Operator's Manual & Parts

GROUNDING PIN
AA210
Note: In Canada, the use of a temporary adapter is not permitted by the Canadian Electrical Code.

Electrical connection

The network voltage must conform to the voltage indicated on the tool name plate.
Under no circumstances should the tool be used when the power supply cable is damaged. A damaged
cable must be replaced immediately by an authorized Customer Service Center. Do not try to repair the
damaged cable yourself. The use of damaged power cables can lead to an electric shock.
WARNING: Always use a Residual Current Device (RCD) also known as a Ground Fault Circuit Interrupter
(GFCI). Use an RCD in a separate control box with one or more socket outlets in accordance with EN
60309-2 with the earthing contact position 1 h. Always use this device whenever using the machine to
reduce the risk of shock hazards. Test and reset the device before each use. Press the "Test" button
to test. Press the "Reset" button to energize the circuit to the machine.
WARNING: Always connect the plug into the wall socket with a drip loop. If the cable leads downward
directly into the wall socket, any water on the cable could run into the socket, causing a hazard.
ASSEMBLY
Thread the water supply assy. Into the hole in the bottom of gearbox and tighten with a wrench.
LIST OF CONTENTS
• Diamond core drilling machine.
• Mounting spacer
• Water feed assembly
• Wrench
COVER OF GROUNDED
OUTLET BOX
(A)
(C)
9
(B)
ADAPTER
GROUNDING
MEANS
METAL SCREW