Advertisement
Safety information
Care during use
Your VivoStick is designed and tested to meet the latest standards of safety
•
Do not walk on the power cord or allow anything to rest on it.
for information technology equipment. However, to ensure your safety, it is
•
Do not spill water or any other liquids on your system.
important that you read the following safety instructions.
•
When the system is turned off, a small amount of electrical current still
Setting up your system
flows. Always unplug the power cord from the power outlets before
cleaning the system.
•
Read and follow all instructions in the documentation before you
•
If you encounter the following technical problems with the product,
operate your system.
unplug the power cord and contact a qualified service technician or
•
Do not use this product near water or a heated source.
your retailer.
•
Make sure you leave plenty of space around the system for ventilation.
–The power cord or plug is damaged.
•
Use this product in environments with ambient temperatures between
–Liquid has been spilled into the system.
1˚C (33.8˚F) and 35˚C (95˚F).
– T he system does not function properly even if you follow the
•
If you use an extension cord, make sure that the total ampere rating
operating instructions.
of the devices plugged into the extension cord does not exceed its
– T he system was dropped or the casing is damaged.
ampere rating.
–The system performance changes.
•
This equipment should be installed and operated with a minimum
distance of 20cm between the radiator and your body.
•
If you notice any of the following conditions (or if you have other
safety concerns), do not use your device: crackling, hissing, popping
sound, or a strong odor or smoke coming from your device. It is normal
CAUTION: Danger of explosion if battery is incorrectly replaced.
for these conditions to appear when an internal electronic component
Replace only with the same or equivalent type recommended
fails in a safe and controlled manner. However, these conditions may
by the manufacturer. Dispose of used batteries according to the
also indicate a potential safety issue. Do not assume that it is a safe
manufacturer's instructions.
failure. Turn off your device. If your device is plugged in, disconnect it
from its power source, and contact technical support for assistance.
•
Magnet: Avoid placing any media that contains magnets or is
The warranty does not apply to the products that have been
sensitive to magnetism, such as credit cards, bank cards, audio/video,
disassembled by users.
tapes, or magnetic memory devices, near your device as you may
lose information stored on that media and devices may be severely
damaged. Media containing information sensitive to magnets should
be kept at least 5 cm away from your device.
•
Pacemakers and other implanted medical devices: VivoStick
receives and transmits using Wi-Fi and Bluetooth technology, which
can interfere with pacemakers and other implanted medical devices. If
you have a pacemaker or other implanted medical device, contact your
physician or medical device manufacturer to make sure it's okay to use
your VivoStick.
ASUS Contact Information
Wireless Operation Channel for Different
Domains
ASUSTeK COMPUTER INC.
N. America
2.412-2.462 GHz
Ch01 through CH11
Address
Japan
2.412-2.484 GHz
Ch01 through Ch14
Telephone
Fax
Europe ETSI 2.412-2.472 GHz
Ch01 through Ch13
Website
Technical Support
Telephone
Fax
Regional notice for Singapore
Online support
ASUS COMPUTER INTERNATIONAL (America)
This ASUS product complies with IMDA Standards.
Complies with
Address
IMDA Standards
Telephone
DB103778
Fax
Website
Technical Support
Support fax
General support +1-812-282-4555
Regional notice for California
Online support
ASUS COMPUTER GmbH (Germany and Austria)
WARNING
Address
Cancer and Reproductive Harm -
Fax
www.P65Warnings.ca.gov
Website
Online contact
Technical Support
Telephone
Support Fax
Online support
Regulatory notices
REACH
Complying with the REACH (Registration, Evaluation, Authorization, and
Restriction of Chemicals) regulatory framework, we publish the chemical
substances in our products at ASUS REACH website at http://csr.asus.com/
english/REACH.htm
ASUS Recycling/Takeback Services
ASUS recycling and takeback programs come from our commitment to the
highest standards for protecting our environment. We believe in providing
solutions for you to be able to responsibly recycle our products, batteries,
other components, as well as the packaging materials. Please go to http://
csr.asus.com/english/Takeback.htm for the detailed recycling information
in different regions.
Lithium-Metal Battery Warning
Coating Notice
IMPORTANT! To provide electrical insulation and
maintain electrical safety, a coating is applied to insulate
the device except on the areas where the I/O ports are
located.
NO DISASSEMBLY
DO NOT throw the VivoStick in municipal waste. This
product has been designed to enable proper reuse
of parts and recycling. This symbol of the crossed out
wheeled bin indicates that the product (electrical,
electronic equipment, and mercury-containing button
cell battery) should not be placed in municipal waste.
Check local technical support services for product
recycling.
4F, No. 150 Li-Te Road, Peitou, Taipei 112, Taiwan
+886-2-2894-3447
+886-2-2890-7798
http://www.asus.com
DECLARATION OF CONFORMITY
+86-21-38429911
Per FCC Part 2 Section 2. 1077(a)
+86-21-58668722, ext. 9101#
http://qr.asus.com/techserv
Responsible Party Name:
800 Corporate Way, Fremont, CA 94539, USA
Address:
+1-510-739-3777
Phone/Fax No: (510)739-3777/(510)608-4555
+1-510-608-4555
http://usa.asus.com
hereby declares that the product
Product Name : VivoStick
+1-812-284-0883
Model Number : TS10
http://qr.asus.com/techserv
Conforms to the following specifications:
FCC Part 15, Subpart B, Unintentional Radiators
Supplementary Information:
Harkort Str. 21-23, D-40880 Ratingen, Germany
This device complies with part 15 of the FCC Rules. Operation is subject to the
+49-2102-959931
following two conditions: (1) This device may not cause harmful interference,
http://www.asus.com/de
and (2) this device must accept any interference received, including interference
http://eu-rma.asus.com/sales
that may cause undesired operation.
Representative Person's Name :
+49-2102-5789555
+49-2102-959911
http://qr.asus.com/techserv
Signature :
Federal Communications Commission
Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
•
This device may not cause harmful interference, and
•
This device must accept any interference received including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
manufacturer's instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
CAUTION: This transmitter must not be co-located or
operated in conjunction with any other antenna or
transmitter. Any changes or modifications not expressly
approved by the grantee of this device could void the
user's authority to operate the equipment.
Asus Computer International
, CA 94539.
800 Corporate Way, Fremont
Steve Chang / President
Date :
Feb. 22, 2016
Ver. 140331
RF exposure warning
Compliance Statement of Innovation,
Science and Economic Development
This equipment must be installed and operated in accordance with provided
instructions and the antenna(s) used for this transmitter must be installed
Canada (ISED)
to provide a separation distance of at least 20 cm from all persons and
must not be co-located or operating in conjunction with any other antenna
This Class B digital apparatus complies with Canadian ICES-003, RSS-210, and
or transmitter. End-users and installers must be provide with antenna
CAN ICES-3(B)/NMB-3(B).
installation instructions and transmitter operating conditions for satisfying
This device complies with Industry Canada license exempt RSS standard(s).
RF exposure compliance.
Operation is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
ISED Radiation Exposure Statement for
Canada
Déclaration de conformité de Innovation,
This equipment complies with ISED radiation exposure limits set forth for an
uncontrolled environment. To maintain compliance with ISED RF exposure
Sciences et Développement économique
compliance requirements, please avoid direct contact to the transmitting
antenna during transmitting. End users must follow the specific operating
Canada (ISED)
instructions for satisfying RF exposure compliance.
Cet appareil numérique de classe B est conforme aux normes canadiennes
Operation is subject to the following two conditions:
ICES-003, RSS-210 et CAN ICES-3(B)/NMB-3(B).
•
This device may not cause interference and
Cet appareil est conforme aux normes CNR exemptes de licence d'Industrie
•
This device must accept any interference, including interference that
Canada. Le fonctionnement est soumis aux deux conditions suivantes : (1)
may cause undesired operation of the device.
cet appareil ne doit pas provoquer d'interférences et (2) cet appareil doit
accepter toute interférence, y compris celles susceptibles de provoquer un
fonctionnement non souhaité de l'appareil.
Advertisement
