Honda Odyssey 2019 Owner's Manual page 64

HANDLING THE UNEXPECTED
Setting Up the Jack
n
1. Place the jack under the jacking
point closest to the tire to be
changed.
2. Turn the end bracket clockwise (as
shown in the image) until the top of
the jack contacts the jacking point.
Make sure that the jacking point tab
is resting in the jack notch.
3. Raise the vehicle, using the jack
handle bar and the jack handle, until
the tire is off the ground.
The vehicle can easily roll off the jack, seriously injuring anyone
underneath.
Follow the directions for changing a tire exactly, and never get under the
vehicle when it is supported only by the jack.
Do not use the jack if it doesn't work properly. Call your dealer or a
professional towing service.
The following instructions must be followed to use the jack safely:
• Do not use the jack with people or luggage in the vehicle.
• Use the jack provided in your vehicle. Other jacks may not support the
weight (load) or fit the jacking point.
• Do not use while the engine is running.
120 |
• Use only where the ground is firm and level.
• Use only at the jacking points.
• Do not get in the vehicle while using the jack.
• Do not put anything on top of or underneath the jack.
Replacing the Flat Tire
n
1. Remove the wheel nuts and flat tire.
2. Mount the compact spare tire.
Replace the wheel nuts and lightly
tighten them.
3. Lower the vehicle and remove the
jack. Tighten the wheel nuts in the
order indicated in the image. Go
around, tightening the nuts, two to
three times in this order. Do not
overtighten the wheel nuts.
If you drive with the spare tire installed,
the low tire pressure/TPMS indicator
appears. The indicator stays on until a
regular tire is installed and the TPMS
system is recalibrated.
Storing the Flat Tire
n
1. Take out the storage bag from the
tool case. Put the flat tire into the
storage bag.
HANDLING THE UNEXPECTED
| 121