Shop for Fluke products online at:
Step 3: Setup the network
Skip this step if you are using mobile router/hotspot for connectivity.
For this step, you will need support from your IT team.
1.
Obtain the WiFi network name and password.
2.
Make sure your network complies with these requirements:
WLAN Standards: 802.11 g/n GHz
Upload speed: 1Mbps (Sustained)
Internet HTTP Proxy: Disabled
Supported Authentication Protocols: WEP, WPA
For a comprehensive list of requirements, see Network
Configuration Requirement for the FC Vibration Sensor at
MyFlukeStore
www.
Vibration Sensor/Gateway
Before you install
Note
.com
1.888.610.7664